Operator Seat Belt Not Retracting {7327} Caterpillar

Caterpillar Products

All Machines

Introduction

The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.

Problem

The seat belt can double over and catch inside the retractor. This issue is sometimes seen as a failure and the seat belts are replaced.

Solution

Show/hide table

Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.

There is a video that contains demonstrations of proper seat belt troubleshooting and maintenance.

By following the procedures documented in a Caterpillar Channel 1 video, the seat belt can be pulled out and corrected.

Note: A CWS login is required to access Caterpillar Channel1. Scan the following QR code with a QR enabled device or copy the link that follows.

Illustration 1	g06402872

Reference: For more information, refer to "Operator Seatbelt Maintenance and Procedures to Fix a Seized Seatbelt" on Caterpillar Channel1.

Illustration 2	g06402878
(D1) 30 ± 5°

Not installing the seat belt at the proper mounting angle can contribute to seat belt retracting issues. Refer to Illustration 2 for correct seat belt mounting angle.