Pistons and Connecting Rods - Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 5R-7425 | 盘车控制装置总成 | 1 |
B | 1P-1861 | 挡圈钳 | 1 |
C | 271-0498 | 涨圈 | 1 |
H | 485-8003 | 工具组件 | 1 |
J | 7X-7699 | 润滑脂 | - |
K | 471-6593 | 工具组件 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 使用工具 (C) 在活塞7上安装活塞环 (6)。
注: 组装第一道环,使带有 "UP-1" 标记的一侧朝向活塞顶部。
注: 组装中间环时使带有 "Up-2" 标记的一侧朝向活塞顶部。
注: 组装油环弹簧端部时使其与活塞环端隙成 180°。
- 组装活塞环后,旋转环,使端隙分离 120°。 机油环端隙必须在销孔平面上。
- 组装前,必须用发动机机油对销 (5) 与孔以及销 (5) 与轴承间的销配合面进行 100% 润滑。
- 将连杆 (8) 置于活塞 (7) 中,并安装活塞销 (5)。
Show/hide table
图 3 g06156977 - 使用工具 (B) 将挡圈 (4) 安装到所示位置,以固定活塞销 (5)。
- 在连杆 (8) 内安装连杆轴承的上半部分。 确保轴承后面的凸舌在连杆 (8) 的轴承凸舌凹槽内。
Show/hide table
图 4 g06157138 - 将工具 (K) 安装到翻边缸套上。
- 将清洁的发动机机油涂在活塞环、缸套孔和连杆轴瓦的上半部分。
Show/hide table
图 5 g01004842 - 使用工具 (H) 压缩活塞环。
Show/hide table
图 6 g06157160 Show/hide table注意 活塞和连杆安装不当可能会使发动机受到严重破坏。
确保连杆孔一侧的倒角与曲轴止推板面相邻。 连杆孔方形的一侧必须与同一曲轴轴径上的其他连杆相邻。 - 在缸套内安装活塞和连杆组件。 确保连杆孔一侧的倒角与曲轴止推板相邻。 连杆孔方形的一侧必须与同一曲轴轴径上的其他连杆相邻。
Show/hide table
图 7 g06156532 - 在连杆盖 (2) 上安装连杆轴轴的下半部分。 确保轴承后面的凸台在连杆盖 (2) 上的轴承凸台凹槽内。 用清洁的发动机机油涂在轴承上。
- 将工具 (J) 涂抹到螺栓螺纹和所有轴承面上。
- 将连杆盖 (2) 放到连杆上并安装螺栓 (1)。
Show/hide table
图 8 g06157182 - 拧紧螺栓 (1) 和 (2) 至扭矩为
90 ± 5 N·m (66 ± 4 lb ft) 。 - 拧紧螺栓 (3) 和 (4) 至扭矩为
90 ± 5 N·m (66 ± 4 lb ft) 。 - 重新拧紧螺栓 (3) 和 (4) 至扭矩为
90 ± 5 N·m (66 ± 4 lb ft) 。 - 再额外拧紧每个螺栓 90° ± 5°。
Show/hide table
图 1 | g01004841 |
Show/hide table
图 2 | g06156652 |
注: 组装活塞环之前,用发动机机油对活塞环槽进行 100% 润滑。
结束:
- 安装活塞冷却喷嘴。
- 安装缸盖。
Caterpillar Information System:
G3516 Petroleum Engine After Starting Engine
G3516 Petroleum Engine Starting the Engine
C7.1 Engines and Generator Sets Water in Fuel - Test
G3516 Petroleum Engine Cold Weather Starting
Installation of G610 Hardware for Cat® Terrain v6.0 for Excavators {7490} Installation of G610 Hardware for Cat® Terrain v6.0 for Excavators {7490}
C7.1 Engines and Generator Sets Valve Position - Test
G3516 Petroleum Engine Configuration Parameters
C7.1 Engines and Generator Sets Throttle Lock - Test
C7.1 Engines and Generator Sets Switch Circuits - Test - Multiposition Throttle Switch
797F and 797F XQ Off-Highway Trucks Machine Systems Brake Accumulator (Parking, Service) - Assemble
797F and 797F XQ Off-Highway Trucks Machine Systems Brake Accumulator (Parking, Service) - Disassemble
A New Heated Insulation Kit Is Now Available for Open Crankcase Ventilation Systems on Certain C15 and C18 Generator Set Engines {1317} A New Heated Insulation Kit Is Now Available for Open Crankcase Ventilation Systems on Certain C15 and C18 Generator Set Engines {1317}
G3516 Petroleum Engine Engine Operation
G3516 Petroleum Engine Manual Stop Procedure
C9.3B Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C7.1 Engines and Generator Sets Customer Passwords
C7.1 Engines and Generator Sets Factory Passwords
C7.1 Engines and Generator Sets ECM Will Not Accept Factory Passwords
C7.1 Engines and Generator Sets Electronic Service Tool Does Not Communicate
C7.1 Engines and Generator Sets Codes that Inhibit Operation of Aftertreatment System
C7.1 Engines and Generator Sets Test ECM Mode
C7.1 Engines and Generator Sets Injector Code - Calibrate
C7.1 Engines and Generator Sets ECM Software - Install
C7.1 Engines and Generator Sets ECM - Replace