Start By:
- Remove the second stage conveyor.
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes to help prevent fluid loss and keep contaminants from entering the system.
- Attach suitable lifting device to conveyor (1) to support conveyor from moving when the hydraulic cylinders are removed from the pivot. The weight of conveyor (1) is approximately
839 kg (1850 lb) .Show/hide tableIllustration 2 g06263706 - Disconnect hose assemblies (4).
- Remove retaining clip (2) and retaining clip (5). Remove pin (3) and pin (6). Remove hydraulic cylinder (7). Repeat process for opposite side of conveyor pivot.
Show/hide table
Illustration 3 g06097110 - Disconnect hose assembly (8) and hose assembly (9).
Show/hide table
Illustration 4 g06097113 - Disconnect hose assembly (10).
Show/hide table
Illustration 5 g06097115 - Remove two bolts (11). Place exhaust assembly (12) out of the way. Repeat process for opposite side of machine.
Show/hide table
Illustration 6 g06097117 - Attach suitable lifting device to pivot assembly (15). The weight of pivot assembly (15) is approximately
408 kg (900 lb) - Remove bolt and washer (13) and bolt and washer (14). Remove pivot assembly (15).
Illustration 1 | g06263688 |
- Install pivot assembly (15) in the reverse order of removal.