Selective Catalytic Reduction Retrofit Aftertreatment Caterpillar


DEF Tank Temperature Is Low

Usage:

SCR EF5
Use this procedure to troubleshoot a low Diesel Exhaust Fluid (DEF) tank temperature. Also, use this procedure if one of the following event codes is active or logged.

Table 1
J1939 Code and Description  CDL Code and Description  Comments 
4368-1
Aftertreatment #1 DEF Tank #2 Temperature : Low - most severe (3) 
E1399 (3)
Low Aftertreatment #1 DEF Tank #2 Temperature 
The Diesel Exhaust Fluid (DEF) tank temperature is low. 
4368-17
Aftertreatment #1 DEF Tank #2 Temperature : Low - least severe (1) 
E1399 (1)
Low Aftertreatment #1 DEF Tank #2 Temperature 
The DEF tank temperature is low. 
4368-18
Aftertreatment #1 DEF Tank #2 Temperature : Low - moderate severity (2) 
E1399 (2)
Low Aftertreatment #1 DEF Tank #2 Temperature 
The DEF tank temperature is low. 

Table 2
Associated Codes 
J1939 Code  CDL Code  Troubleshooting Procedure 
4368-3  3135-3  Troubleshooting, "DEF Tank Sensor - Test" 
4368-4  3135-4  Troubleshooting, "DEF Tank Sensor - Test" 

Probable Causes

  • Codes

  • Sensor

Recommended Actions

Table 3
Troubleshooting Test Steps  Values  Results 

1. Check for Codes

A. Turn the breaker to the ON position.

B. Connect Cat® Electronic Technician (ET) to the service tool connector.

C. Look for active codes that are associated with the system for the event code.
 

Codes
 

Result: An associated code is active.

Repair: Troubleshoot any associated codes before continuing with this test.

Result: A code is active or logged.

Proceed to Test Step 2.
 

2. Check the DEF Tank #2 Temperature Sensor

A. Turn the breaker to the ON position.

B. Connect Cat ET.

C. Use Cat ET to monitor the following temperature:

- "Cabinet Temperature"
- "DEF Tank #2 Temperature"
 

Sensor
 

Result: The "DEF Tank #2 Temperature" is within 5° C (9° F) of the "Cabinet Temperature".

Repair:The DEF Tank temperature is too low. Contact your TC for assistance.

Result: The "DEF Tank #2 Temperature" is not within 5° C (9° F) of the "Cabinet Temperature".

Repair: A failed DEF tank temperature sensor has been detected. Replace the DEF header assembly.

Verify that the repair eliminated the problem.
 

If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).

Caterpillar Information System:

Selective Catalytic Reduction Retrofit Aftertreatment DEF Tank Temperature Is High
Selective Catalytic Reduction Retrofit Aftertreatment DEF Tank Level Is Low
Selective Catalytic Reduction Retrofit Aftertreatment DEF Tank Level Is High
Selective Catalytic Reduction Retrofit Aftertreatment DEF Pressure Is Low
Selective Catalytic Reduction Retrofit Aftertreatment DEF Pressure Is High
Selective Catalytic Reduction Retrofit Aftertreatment DEF Does Not Purge
Selective Catalytic Reduction Retrofit Aftertreatment Clean Emissions Module Has High Oxygen Level
Selective Catalytic Reduction Retrofit Aftertreatment Air Assist Pressure Is Low
Selective Catalytic Reduction Retrofit Aftertreatment Air Assist Pressure Is High
C175 Tier 4 Final Engines for Off-Highway Trucks DEF Controller Resistor - Test
793F Off-Highway Truck Exhaust Outlet Nitrogen Oxide Sensor - Replace
793F Off-Highway Truck Exhaust Inlet Nitrogen Oxide Sensor - Replace
Selective Catalytic Reduction Retrofit Aftertreatment NOx Conversion Is Low
Selective Catalytic Reduction Retrofit Aftertreatment SCR Catalyst Inlet Pressure Is High
Selective Catalytic Reduction Retrofit Aftertreatment SCR Catalyst Inlet Pressure Is Low
Selective Catalytic Reduction Retrofit Aftertreatment Data Link - Test
Selective Catalytic Reduction Retrofit Aftertreatment DEF Pump Motor - Test
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Signal (Analog, Active) - Test
Selective Catalytic Reduction Retrofit Aftertreatment System Overview
Selective Catalytic Reduction Retrofit Aftertreatment Diagnostic Trouble Codes
C4.4 Generator Sets Air Inlet and Exhaust System
C4.4 Generator Sets Turbocharger - Inspect
New Cylinder Head Gasket on Certain C3.4 Engines {1100, 1103, 1104, 1105, 1108, 1109, 1115, 1117, 1121, 1124, 1125} New Cylinder Head Gasket on Certain C3.4 Engines {1100, 1103, 1104, 1105, 1108, 1109, 1115, 1117, 1121, 1124, 1125}
3512E Engines Turbocharger Inlet Temperature Sensor - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.