Rotor - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 439-3940 | Bracket As. | 2 |
B | 439-3942 | Bracket As. | 2 |
Start By:
- Remove terminal box.
- Remove exciter.
- Remove bolts (3) and repeat for the other side. Remove upper cover (1) and lower cover (2).
Show/hide table
Illustration 2 g03891811 - Install Tooling (A) onto adapter (5). Use suitable lifting device to position generator assembly (6) with coupling (4) facing up. The weight of generator assembly (6) is approximately
1883 kg (4151 lb) . Use suitable cribbing to support generator assembly (6). Take care to ensure that the terminal bus bar does not contact the ground.Show/hide tableIllustration 3 g03891988 - Remove retaining straps (7) if necessary.
Show/hide table
Illustration 4 g03891995 - Remove two bolts (8). Ensure that these bolts are 180 degrees from each other to ensure that the assembly will lift evenly.
Show/hide table
Illustration 5 g03892011 Show/hide tableIllustration 6 g03892042 - Install Tooling (B). Use suitable lifting device to remove rotor assembly (9). Take care to ensure that rotor remains clear of the stator throughout to procedure to avoid damaging either component.
Show/hide table
Illustration 1 | g03891775 |
- Install rotor assembly (9) in the reverse order of removal.
Caterpillar Information System:
3516B Generator Set Engines with Dynamic Gas Blending Injector Solenoid - Test
C1.7 and C2.2 Industrial Engine Engine Top Speed Is Not Obtained
EMCP4.2B Custom Event Is Not Present
EMCP4.2B Diagnostic Capabilities
EMCP4.2B Service Tools
EMCP4.2B General Information
EMCP4.2B Monitoring Software for Computer
EMCP4.2B Discrete Input/Output Module
EMCP4.2B Resistive Temperature Device Module
EMCP4.2B Thermocouple Module - EMCP 4.2 only
C1.7 and C2.2 Industrial Engine Engine Overspeeds
EMCP4.2B Annunciator Module
C1.7 and C2.2 Industrial Engine Oil Contains Fuel
2015/09/17 Cat® Reman Announces Additions to Sea Water Pump Portfolios {1371}
2015/09/15 A Guide to Reman Product Markings is Now Available {7754}
2015/09/17 A Guide to Reman Product Markings is Now Available {7754}
2015/09/18 A Guide to Reman Product Markings is Now Available {7754}
2015/09/17 A Procedure to Use the Correct Mounting Bolts with the 10R-2356 Flywheel As is Available {1156}
2015/09/18 A Procedure to Use the Correct Mounting Bolts with the 10R-2356 Flywheel As is Available {1156}
2015/09/18 The Required Parts for Installing Turbochargers on Certain 2007 On-Highway Truck Engines Is Published {1052}
390F Excavator Stopping the Engine
C13 Generator Set Maintenance Interval Schedule - Prime Power
C13 Generator Set Maintenance Interval Schedule - Standby
SRMP Electric Power Generation SRMP Generator Exciter - Remove and Install