C280-08 Tier 4 Engine Caterpillar

Removal Procedure

Start By:

1. Remove the exhaust manifold shields.

Show/hide table

NOTICE
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table

Illustration 1	g01315571

1. Disconnect the thermocouples from the segments of the exhaust manifold that are being removed.

2. Remove the adapters, if necessary.

3. Loosen bolts (1) that mount exhaust manifold (2) to the cylinder head from the segment of the exhaust manifold that is on the end. Loosen bolts (3) that mount the segment of the exhaust manifold that is on the end to bellows (4). Loosen bolts (5) that mount bellows (4) that is on the end to the adjacent exhaust manifold.

4. Repeat Step 1 through Step 3 for the remaining segments of exhaust manifold (2). Move toward the turbocharger when you are loosening all of the remaining bolts.

5. Return to the segment of the exhaust manifold that is on the end. Attach a suitable lifting device to the segment of the exhaust manifold. The weight of each segment of exhaust manifold (2) is approximately 25 kg (55 lb).

6. Remove bolts (1) that mount exhaust manifold (2) to the cylinder head from the segment of the exhaust manifold that is on the end. Remove bolts (3) that mount the segment of the exhaust manifold that is on the end to bellows (4). Remove the segment of exhaust manifold (2). Remove the gasket. Remove bolts (5) that mount bellows (4) that is on the end to the adjacent exhaust manifold. Remove the bellows.

7. Repeat Step 5 and Step 6 for the remaining segments of exhaust manifold (2). Move toward the turbocharger when you are removing all of the remaining bolts.

Installation Procedure

1. Apply Tooling (A) to the threads of the bolts of the exhaust manifold, the washers, the bolts of the bellows, the plugs, and the adapters before installation.
   Show/hide table

   Illustration 2	g01315571

2. Attach a suitable lifting device to a segment of the exhaust manifold. The weight of each segment of exhaust manifold (2) is approximately 25 kg (55 lb). Position the gasket and exhaust manifold (2) on the cylinder head. Install bolts (1) that mount the exhaust manifold to the cylinder head. Tighten the bolts finger tight.

   Note: Do not tighten these bolts to the torque specification at this time.

3. Repeat Step 2 for all segments of exhaust manifold (2).

4. Install bellows (4), bolts (5), and bolts (3) on the exhaust manifold. Tighten the bolts finger tight.

5. Tighten bolts (1) that mount exhaust manifold (2) to the cylinder head to a torque of 135 ± 20 N·m (100 ± 15 lb ft).

6. Tighten bolts (3) and bolts (5) to a torque of 55 ± 10 N·m (41 ± 7 lb ft).

7. If the adapters were removed, tighten the adapters to a torque of 200 ± 25 N·m (150 ± 20 lb ft).

End By:

1. Install the exhaust manifold shields.