Air Lines
Show/hide table
Illustration 1 | g03836727 |
Show/hide table
Specification for 338-3649 Air Lines Gp | |||
---|---|---|---|
Item | Qty | Part | Specification Description |
1 | 16 | 216-2211 Clamp | Use the following procedure to tighten the clamp: 1. Center clamps within the marking on the hose. 2. Orient clamps, so that T-bolts are at minimum 90 degree apart. 3. Tighten the clamp to |
2 | 8 | 6V-3917 O-Ring Seal | Lubricate the bore lightly with 5P-3975 Rubber Lubricant. |
Caterpillar Information System:
C280 Marine Engines Circuit Breaker - Test
3512C and 3516C Industrial Engines Engine Oil Filter
3500 Industrial Engines Fuel Injector Mechanism
Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490} Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490}
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Left-Hand Service Oil
3516B Generator Set Engines with Dynamic Gas Blending Exhaust System Contains Oil
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Combined Circuit Keel Cooling
C280-08 Tier 4 Engine Exhaust Manifold Shield - Remove and Install
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Right-Hand Service
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Replace
2015/08/14 A New Control Valve Assembly for Fuel Is Used on Certain 3500 Marine Engines {1261}
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Inspect
G3606 and G3608 Engines Aftercooler - Disassemble
C9.3 Marine Engine Coolant Temperature Sensor - Remove and Install
3516E Generator Set Engine Sensor Calibration Required - Test
C9.3 Marine Engine Engine Oil Pressure Sensor - Remove and Install
C280-08 Tier 4 Engine Exhaust Manifold - Remove and Install
C280-08 Tier 4 Engine Aftercooler - Remove and Install
C280-08 Tier 4 Engine Turbocharger - Remove and Install
C280-08 Tier 4 Engine Air Inlet Shutoff - Remove and Install
C9.3 Marine Engine Fuel Pressure Sensor - Remove and Install
C9.3 Marine Engine Speed/Timing Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Relay - Test - ECM Main Relay
C9.3 Marine Engine Inlet Manifold Temperature Sensor - Remove and Install