C9.3 Marine Engine Caterpillar


Engine Oil Pan - Remove and Install - Right-Hand Service

Usage:

C9.3 C93

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
Loctite 5900 


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.

Dispose of all fluids according to local regulations and mandates.


  1. Drain the engine oil and filter. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the proper draining and filling procedures.


    Illustration 1g03836288

  2. Remove nut (1) and oil level gauge (2).


    Illustration 2g03836301

  3. Remove bolts (3), engine oil pan (4), and the gasket.

Installation Procedure

  1. Install engine oil pan (4) in the reverse order of removal.


      Illustration 3g06152144

    1. Tooling (A) should be applied at Locations (X) for a width of 4.00 ± 1.00 mm (0.158 ± 0.040 inch). Apply Tooling (A) to the joints.

Caterpillar Information System:

3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Replace
2015/08/14 A New Control Valve Assembly for Fuel Is Used on Certain 3500 Marine Engines {1261}
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Inspect
2015/07/07 An Improved Housing for the Throttle Inlet Is Used on Certain G3500 Engines {1071}
12M Motor Grader Wheel Lean Bearings - Lubricate
3500B High Displacement Locomotive Engines Fuel Injector Mechanism
C9.3 Marine Engine Cylinder Head - Remove and Install
PM820, PM822, and PM825 Cold Planer Lifting and Tying Down the Machine - Fixed Conveyor
3600 Distillate Fuel Engines Maintenance Interval Schedule
C9.3 Marine Engine Valve Mechanism Cover - Remove and Install
C9.3 Marine Engine Cylinder Block Cover - Remove and Install
3500 Engines Housing (Front)
C280-08 Tier 4 Engine Exhaust Manifold Shield - Remove and Install
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Combined Circuit Keel Cooling
3516B Generator Set Engines with Dynamic Gas Blending Exhaust System Contains Oil
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Left-Hand Service Oil
Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490} Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490}
3500 Industrial Engines Fuel Injector Mechanism
3512C and 3516C Industrial Engines Engine Oil Filter
C280 Marine Engines Circuit Breaker - Test
3512C and 3516C Industrial Engines Air Lines
G3606 and G3608 Engines Aftercooler - Disassemble
C9.3 Marine Engine Coolant Temperature Sensor - Remove and Install
3516E Generator Set Engine Sensor Calibration Required - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.