Procedure to Improve Reporting into VisionLink after Re-Registration of Product Link Systems PL121/321 {7606}
- Caterpillar Products:
- All
ReferenceSpecial Instruction, REHS2365, "Installation Guide for Product Link PL121SR and PL321".
In the standard re-registration process, assets are first de-registered and then re-registered with either a new device or the same device. Occasionally, the two messages created by these actions get out of order to VisionLink resulting in de-registration of the asset. Check registration status for the asset in the VisionLink Store.
If the machine is de-registered in the VisionLink Store, then take one of the following actions:
- Have your Technical Communicator (TC) contact the Dealer Solutions Network (DSN) to register the machine. This may take several days to take effect. Have the machine serial number and Product Link module number available when contacting DSN.
- Check using Cat ET to ensure that the registration message transmits from the Product Link message queue before leaving the machine.
Refer to the Special Instruction given in the reference section, for more information on re-registering Product Link PL121/PL321.
Caterpillar Information System:
C8.7 and C12.9 Marine Engines Oil Filter Differential Pressure Problem
794 AC Off-Highway Truck Power Train Phase Module - Remove and Install - Chopper
G3512 Generator Set Fumes Disposal Filter Element - Inspect
C8.7 Marine Engines Flywheel Housing
G3600 A4 Engines Cooling System
C8.7 Marine Engines Engine Oil Filter Base
C8.7 Marine Engines Connecting Rod Bearing Journal
C8.7 Marine Engines Piston and Rings
C8.7 Marine Engine Expansion Tank - Remove and Install
C8.7 Marine Engines Cylinder Head Valves
C8.7 Marine Engines Main Bearing Journal
794 AC Off-Highway Truck Power Train Resistor - Remove and Install - Active Resistors - High Voltage Warning System
C8.7 and C12.9 Marine Engines Electromagnetic Clutch - Test
C8.7 and C12.9 Marine Engines ECM - Replace
794 AC Off-Highway Truck Power Train Phase Module - Remove and Install
794 AC Off-Highway Truck Power Train Interface Module - Remove and Install - Motor No. 1
794 AC Off-Highway Truck Power Train Interface Module - Remove and Install - Motor No.2
C7.1 Engines Relay - Test - ECM Power Relay
C2.2 Engines for Caterpillar Built Machines Engine Oil Pump - Install
C4.4 and C7.1 Engines Relay - Test - Start Relay
C7.1 Engines Sensor Signal (Analog, Passive) - Test
3500 Generator Sets with Dynamic Gas Blending Product Lifting
2015/06/12 A New Engine Wiring Harness Is Available for Certain Cat 3512C Engines {1000, 1408}
794 AC Off-Highway Truck Power Train Inverter - Remove and Install - Retarding Grid Blower