Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
- Disconnect harness assembly (1) and harness assembly (2).
- Remove pressure sensor (4).
- Remove bolts (3) and remove pressure sensor (5).
Show/hide table
Illustration 1 | g03783919 |
- Install pressure sensor (4) and pressure sensor (5) in the reverse order of removal.
- Tighten bolts (3) to a torque of
20 ± 3 N·m (177 ± 27 lb in) . - Tighten pressure sensor (4) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
- Tighten bolts (3) to a torque of
Caterpillar Information System:
C2.2 Engines for Caterpillar Built Machines Crankshaft
C13 Generator Set Engine Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Generator Set Engine Pressure Sensor (DPF) - Remove and Install
Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052} Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052}
C13 Generator Set Engine Temperature Sensor (Catalyst Inlet) - Remove and Install
Final Drive Motor Housings Are Available for Certain Excavators {4050} Final Drive Motor Housings Are Available for Certain Excavators {4050}
3516B Generator Set Engines with Dynamic Gas Blending Fuel Pressure Is Low
C13 Generator Set Engine Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
C280 Marine Engines Fuel Pressure Is High
C13 Generator Set Engine Pressure Sensor (ARD Combustion Air) - Remove and Install
C4.4 and C6.6 Engines Crankcase Breather Ejects Oil
Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480} Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480}
C13 Generator Set Engine Pressure Sensor (NRS Differential) - Remove and Install
C13 Generator Set Engine Pressure Sensor (NRS Absolute) - Remove and Install
2015/05/15 A New Starter Is Now Available for Certain Cat® Generator Set Engines {1453}
C13 Generator Set Engine Boost Pressure Sensor - Remove and Install
C13 Generator Set Engine Inlet Air Temperature Sensor - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending Component Location
C13 Generator Set Engine Venturi Tube - Remove and Install
C7.1 Engines Aftertreatment Identification Module - Test
C2.2 Engines for Caterpillar Built Machines Piston and Rings
C7.1 Engines CAN Data Link - Test
C2.2 Engines for Caterpillar Built Machines Connecting Rod
C2.2 Engines for Caterpillar Built Machines Cylinder Head