C13 Generator Set Engine Caterpillar


Pressure Sensor (ARD Combustion Air) - Remove and Install

Usage:

C13 XQ375 X3F

Removal Procedure



    Illustration 1g03783181

  1. Remove panel (1).


    Illustration 2g03783192

  2. Remove cable strap (5) and clip (3).

  3. Disconnect harness assembly (2) and remove pressure sensor (4).

Installation Procedure

  1. Install pressure sensor (4) in the reverse order of removal.

      Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.

    1. Tighten pressure sensor (4) to a torque of 10 ± 2 N·m (89 ± 18 lb in).

Caterpillar Information System:

C4.4 and C6.6 Engines Crankcase Breather Ejects Oil
Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480} Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480}
C13 Generator Set Engine Fuel Temperature Sensor - Remove and Install
C13 Generator Set Engine Fuel Pressure Sensor - Remove and Install
C13 Generator Set Engine Crankcase Pressure Sensor - Remove and Install
C13 Generator Set Engine Engine Oil Pressure Sensor - Remove and Install
3512E Engines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
2015/01/23 New Varistor is Now Available for Certain Engines and Generator Sets {4450}
3512E Engines Engine Oil Temperature Sensor - Remove and Install
3512E Engines Inlet Air Temperature Sensor - Remove and Install
C3.3 Industrial Engine Reference Material
3600 Heavy Fuel Engines Maintenance Interval Schedule - Heavy Fuel
C280 Marine Engines Fuel Pressure Is High
C13 Generator Set Engine Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending Fuel Pressure Is Low
Final Drive Motor Housings Are Available for Certain Excavators {4050} Final Drive Motor Housings Are Available for Certain Excavators {4050}
C13 Generator Set Engine Temperature Sensor (Catalyst Inlet) - Remove and Install
Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052} Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052}
C13 Generator Set Engine Pressure Sensor (DPF) - Remove and Install
C13 Generator Set Engine Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C2.2 Engines for Caterpillar Built Machines Crankshaft
C13 Generator Set Engine Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Generator Set Engine Pressure Sensor (NRS Differential) - Remove and Install
C13 Generator Set Engine Pressure Sensor (NRS Absolute) - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.