Engine Oil Pressure Sensor - Remove and Install
- Disconnect harness assembly (2) and remove engine oil pressure sensor (1).
Show/hide table
Illustration 1 | g03782659 |
- Install engine oil pressure sensor (1) in the reverse order of removal.
- Tighten engine oil pressure sensor (1) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.
- Tighten engine oil pressure sensor (1) to a torque of
Caterpillar Information System:
3512E Engines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
2015/01/23 New Varistor is Now Available for Certain Engines and Generator Sets {4450}
3512E Engines Engine Oil Temperature Sensor - Remove and Install
3512E Engines Inlet Air Temperature Sensor - Remove and Install
C3.3 Industrial Engine Reference Material
3600 Heavy Fuel Engines Maintenance Interval Schedule - Heavy Fuel
C32 Marine Engine Maintenance Interval Schedule - Engines Which Are Rated "B" and Engines Which Are Rated "C"
C32 Marine Engine Maintenance Interval Schedule - Engines Which Are Rated "E"
G3600 A4 Engines Pressure Regulating Valve
G3600 A4 Engines Engine Governing - Adjust
G3600 A4 Engines General Information (Electronic Control System)
Generators for C15/C18 Engines Mechanical Features
C13 Generator Set Engine Crankcase Pressure Sensor - Remove and Install
C13 Generator Set Engine Fuel Pressure Sensor - Remove and Install
C13 Generator Set Engine Fuel Temperature Sensor - Remove and Install
Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480} Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480}
C4.4 and C6.6 Engines Crankcase Breather Ejects Oil
C13 Generator Set Engine Pressure Sensor (ARD Combustion Air) - Remove and Install
C280 Marine Engines Fuel Pressure Is High
C13 Generator Set Engine Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending Fuel Pressure Is Low
Final Drive Motor Housings Are Available for Certain Excavators {4050} Final Drive Motor Housings Are Available for Certain Excavators {4050}
C13 Generator Set Engine Temperature Sensor (Catalyst Inlet) - Remove and Install
Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052} Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052}