Engine Oil Temperature Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect harness assembly (1) for engine oil temperature sensor (2).
- Remove engine oil temperature sensor (2).
- Remove O-ring seal from engine oil temperature sensor (2) and discard.
Show/hide table
| |
| Illustration 1 | g03781735 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install engine oil temperature sensor (2) in the reverse order of removal.
- Lubricate a new O-ring seal with clean engine oil. Install new O-ring seal onto engine oil temperature sensor (2).
- Tighten the engine oil temperature sensor (2) to a torque of
20 ± 3 N·m (177 ± 27 lb in)
Show/hide table
|
| |
| Illustration 2 | g03781735 |
Caterpillar Information System:
3512E Engines Inlet Air Temperature Sensor - Remove and Install
C3.3 Industrial Engine Reference Material
3600 Heavy Fuel Engines Maintenance Interval Schedule - Heavy Fuel
C32 Marine Engine Maintenance Interval Schedule - Engines Which Are Rated "B" and Engines Which Are Rated "C"
C32 Marine Engine Maintenance Interval Schedule - Engines Which Are Rated "E"
G3600 A4 Engines Pressure Regulating Valve
G3600 A4 Engines Engine Governing - Adjust
G3600 A4 Engines General Information (Electronic Control System)
Generators for C15/C18 Engines Mechanical Features
C3.3 Industrial Engine Engine Operation
C4.4 and C6.6 Engines Valve Lash Is Excessive
G3600 A4 Engines Ignition System
2015/01/23 New Varistor is Now Available for Certain Engines and Generator Sets {4450}
3512E Engines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Generator Set Engine Engine Oil Pressure Sensor - Remove and Install
C13 Generator Set Engine Crankcase Pressure Sensor - Remove and Install
C13 Generator Set Engine Fuel Pressure Sensor - Remove and Install
C13 Generator Set Engine Fuel Temperature Sensor - Remove and Install
Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480} Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480}
C4.4 and C6.6 Engines Crankcase Breather Ejects Oil
C13 Generator Set Engine Pressure Sensor (ARD Combustion Air) - Remove and Install
C280 Marine Engines Fuel Pressure Is High
C13 Generator Set Engine Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending Fuel Pressure Is Low