Inlet Air Temperature Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1) from inlet air temperature sensor (2).
- Remove inlet air temperature sensor (2).
- Remove O-ring seal from inlet air temperature sensor (2) and discard.
Show/hide table
Illustration 1 | g06201657 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install inlet air temperature sensor (2) in the reverse order of removal.
- Lubricate a new O-ring seal with clean engine oil. Install the new O-ring seal onto inlet air temperature sensor (2).
- Tighten the inlet air temperature sensor (2) to a torque of
24 ± 3 N·m (212 ± 27 lb in)
Caterpillar Information System:
C3.3 Industrial Engine Reference Material
3600 Heavy Fuel Engines Maintenance Interval Schedule - Heavy Fuel
C32 Marine Engine Maintenance Interval Schedule - Engines Which Are Rated "B" and Engines Which Are Rated "C"
C32 Marine Engine Maintenance Interval Schedule - Engines Which Are Rated "E"
G3600 A4 Engines Pressure Regulating Valve
G3600 A4 Engines Engine Governing - Adjust
G3600 A4 Engines General Information (Electronic Control System)
Generators for C15/C18 Engines Mechanical Features
C3.3 Industrial Engine Engine Operation
C4.4 and C6.6 Engines Valve Lash Is Excessive
G3600 A4 Engines Ignition System
3512E Engines Air Cleaner - Remove and Install
3512E Engines Engine Oil Temperature Sensor - Remove and Install
2015/01/23 New Varistor is Now Available for Certain Engines and Generator Sets {4450}
3512E Engines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Generator Set Engine Engine Oil Pressure Sensor - Remove and Install
C13 Generator Set Engine Crankcase Pressure Sensor - Remove and Install
C13 Generator Set Engine Fuel Pressure Sensor - Remove and Install
C13 Generator Set Engine Fuel Temperature Sensor - Remove and Install
Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480} Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480}
C4.4 and C6.6 Engines Crankcase Breather Ejects Oil
C13 Generator Set Engine Pressure Sensor (ARD Combustion Air) - Remove and Install
C280 Marine Engines Fuel Pressure Is High
C13 Generator Set Engine Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install