Fuel Temperature Sensor - Remove and Install
Removal Procedure
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the fuel supply valve to the OFF position.
Show/hide table
 | |
| Illustration 1 | g03639725 |
- Disconnect harness assembly (1) .
- Remove fuel temperature sensor (2) from the fuel filter base.
- Remove the O-ring seal from fuel temperature sensor (2) .
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install fuel temperature sensor (2) in the reverse order of removal.
- Tighten fuel temperature sensor (2) to a torque of 20 ± 5 N·m (15 ± 4 lb ft).
Caterpillar Information System:
C4.4 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
390F Excavator C18 Engine Supplement Hood - Remove and Install - Clean Emissions Module
C4.4 Marine Generator Set Sea Water Pump Pressure Is Low
390F Excavator Machine Systems Control Valve (Boom Lowering)
UPS 750 Uninterruptible Power Supply System Operational Modes
G3600 A4 Engines Refill Capacities
374F Excavator Lifting and Tying Down the Machine
390F MHPU Mobile Hydraulic Power Unit Machine System Relief Valve (Main)
390F MHPU Mobile Hydraulic Power Unit Machine System Main Hydraulic Pump
G3600 A4 Engines Safety Messages
C27 and C32 Engines for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install
2014/05/30 New Rocker Arms Are Used for Certain C27 and C32 Machine Engines {1102, 1123}
390F Excavator Engine Enclosure - Remove and Install
374F Excavator Air Cleaner Dust Valve - Clean/Inspect
C27 and C32 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install - Right Side and Left Side
2014/03/07 A New Jacket Water Elbow and Tube Assembly Are Used on Certain 3516C HD Marine Tier 3 Engines {1380}
C27 and C32 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
C4.4 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Remove
C4.4 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
390F Excavator C18 Engine Supplement Engine Rear Mount - Remove and Install
C175-16 Petroleum Generator Set Engines Control Panel
390F Excavator C18 Engine Supplement Engine - Remove and Install
390F Excavator Fan Guard - Remove and Install - Rear