C27 and C32 Engines for Caterpillar Built Machines Caterpillar


Fuel Pressure Sensor - Remove and Install

Usage:

854K 221

Removal Procedure


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.

Dispose of all fluids according to local regulations and mandates.



NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g03637761

  1. Turn the fuel supply valve to the OFF position.

  2. Disconnect harness assembly (1).

  3. Remove fuel pressure sensor (2) from the fuel filter base.

  4. Remove the O-ring seal from fuel pressure sensor (2).

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.


  1. Install fuel pressure sensor (2) in the reverse order of removal.

    1. Tighten fuel pressure sensor (2) to a torque of 10 ± 2 N·m (89 ± 18 lb in).

Caterpillar Information System:

2014/05/30 New Rocker Arms Are Used for Certain C27 and C32 Machine Engines {1102, 1123}
C27 and C32 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
390F Excavator Radiator - Remove and Install - Rear
349F and 352F Excavators Machine System Specifications Air Conditioner Lines
C3.4B Engines Valve Position - Test
349F and 352F Excavators Machine System Specifications Hydraulic Tank Mounting
C3.4B Engines Switch Circuits - Test - Engine Oil Pressure Switch
C8.7 Marine Engines Air Inlet and Exhaust System
Required Parts for Installing Turbochargers on Certain 2007 On-Highway Truck Engines {1052, 1053} Required Parts for Installing Turbochargers on Certain 2007 On-Highway Truck Engines {1052, 1053}
390F Excavator Radiator - Remove and Install - Front
374F Excavator Camera Harness - Disconnect and Connect
374F Excavator Machine Systems BLCV and SLCV - Calibrate - If Equipped
G3600 A4 Engines Safety Messages
390F MHPU Mobile Hydraulic Power Unit Machine System Main Hydraulic Pump
390F MHPU Mobile Hydraulic Power Unit Machine System Relief Valve (Main)
374F Excavator Lifting and Tying Down the Machine
G3600 A4 Engines Refill Capacities
UPS 750 Uninterruptible Power Supply System Operational Modes
390F Excavator Machine Systems Control Valve (Boom Lowering)
C4.4 Marine Generator Set Sea Water Pump Pressure Is Low
390F Excavator C18 Engine Supplement Hood - Remove and Install - Clean Emissions Module
C4.4 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
390F Excavator Engine Enclosure - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.