794 AC Off-Highway Truck Caterpillar


Frame and Body Support Pads - Clean/Inspect

Usage:

794 AC HRT
Note: The graphics that are shown are for illustrative purposes. This procedure is an in-chassis inspection.

------ WARNING! ------

When it is necessary to work under the machine with the body (bed) raised, attach the body (bed) retaining cables to the rear tow points. Install the rear tow point pins through the ends of the retaining cables.

Failure to properly secure the body (bed) may result in personal injury or death.


Note: In order to access the body support pads and areas of the frame, it may be necessary to use a portable access system (ladder, stair assembly, man lift, or other portable access system) that is suitable and compliant to local regulations.

  1. Secure the dump body in the fully raised position and prepare the machine for maintenance. Refer to Operation and Maintenance Manual, "Prepare the Machine for Maintenance".


    Illustration 1g03421074

  2. Clean the body support pads. Visually inspect body support pads.

  3. Remove the truck body retaining cables and lower the dump body. For the proper procedure, refer to Operations and Maintenance Manual, "Cable (Truck Body Retaining)".

  4. Visually inspect each of the body support pads. Look for damage or uneven wear of the body support pads. Look for gaps between the body support pads and the mating surfaces. If problems are found, consult your Cat dealer for more information or for specific repair procedures.

Caterpillar Information System:

794 AC Off-Highway Truck Frame and Body - Inspect
794 AC Off-Highway Truck Engine Air Precleaner - Clean
794 AC Off-Highway Truck Cab Air Filter - Clean/Replace
794 AC Off-Highway Truck Automatic Lubrication Reservoir - Fill
XQC1600 Power Module Sound Information
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Modbus Register Map
XQC1600 Power Module Product Description
PM620 and PM622 Cold Planer Slope Operation
2013/08/19 New Software Is Now Available For All Cat® Products With PL522 China System {7606, 7620}
C175-16 Locomotive Engine Flywheel Housing Cover
C4.4 Industrial Engine Sensors and Electrical Components
C4.4 Industrial Engine Monitoring System - Engine Indicators and Aftertreatment Indicators
C175-16 Locomotive Engine Exhaust Diffuser Adapter
C175-16 Locomotive Engine Flywheel
349F and 352F Excavator Machine System Wiring Harness (Open Circuit) - Test
349F and 352F Excavator Machine System Wiring Harness (Short Circuit) - Test
C15 and C18 Engines for China On-Highway Phase IV Event Codes
C4.4 Industrial Engine Diagnostic Flash Code Retrieval
349F and 352F Excavators Parking
C4.4 Industrial Engine Configuration Parameters
C15 and C18 Engines for China On-Highway Phase IV ARD Is Disabled
C15 and C18 Engines for China On-Highway Phase IV Coolant Level Is Low
C15 and C18 Engines for China On-Highway Phase IV Coolant Temperature Is High
C15 and C18 Engines for China On-Highway Phase IV Crankcase Pressure Is High
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.