C7.1 Engines Caterpillar


Valve Mechanism Cover Base - Remove and Install

Usage:

525D 2L5

拆卸步骤

表 1
所需工具 
工具  零件号  零件描述  数量 
A  1P-1860  挡圈钳 

开始:

  1. 拆下气门机构盖。 请参考拆解和组装, "气门机构盖 - 拆卸和安装"以了解正确步骤。

  2. 拆下燃油喷油管。 有关正确的步骤,请参阅拆解和组装, "燃油喷油管 - 拆卸"。


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损並縮短部件使用寿命。




图 1g03381182

  1. 遵循步骤 1.a 至步骤 1.f 拆下电子单体喷油器 (2) 的线束组件 (5)。

    1. 用深孔套筒将接头 (1) 从电子单体喷油器 (2) 上拆下。

    2. 切断电缆带 (3)。 将电缆带的其余部分从气门机构盖底座 (4) 上拆下。

    3. 将线束组件 (7) 从线束组件 (5) 上断开。

    4. 用工具 (A) 将卡环 (6) 从线束组件 (5) 上拆下。

    5. 将线束组件 (5) 从气门机构盖底座 (4 )中取出。

    6. 将 O 形密封圈 (8) 从线束组件 (5) 上拆下。


    图 2g03381206


    图 3g03381208

  2. 按相反的数字顺序松开螺栓 (9)。 参考图 3。 按相反的数字顺序松开螺栓有助于防止气门机构盖底座 (4) 变形。

  3. 将螺栓 (9) 从气门机构盖底座 (4) 上拆下。

  4. 将气门机构盖底座 (4) 从缸盖上拆下。

  5. 拆下密封垫 (10)。

安装步骤

表 2
所需工具 
工具  零件号  零件描述  数量 
1P-1860  挡圈钳 
1U-6396  O 形圈组装固定胶 
导向螺柱
M8 × 100 mm 
导向螺柱
M8 × 50 mm 
247-5377  扭矩扳手 


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损並縮短部件使用寿命。


  1. 清洁气门机构盖底座和缸盖。 确保密封垫表面无损坏。


    图 4g03382280
    定位销位置


    图 5g03381206


    图 6g03381208

  2. 将工具 (C) 和工具 (D) 安装到缸盖上的位置 (X)。

  3. 将新密封垫 (10) 与工具 (C) 和工具 (D) 对齐。 将密封垫安装到缸盖上。 确保密封垫朝向正确。

  4. 将气门机构盖底座 (4) 安置到缸盖上。

  5. 将螺栓 (9) 安装到气门机构盖底座 (4 )上,用手拧紧。

  6. 拆下工具 (C) 和工具 (D)。 将其余的螺栓 (9) 安装到气门机构盖底座 (4 )上。

  7. 按图 6 中所示顺序拧紧螺栓 (9) 至扭矩为 25 N·m (221 lb in)


    图 7g03381182


    图 8g03382344

  8. 如有必要,安装电子单体喷油器的线束组件。 按照步骤 8.a 至步骤 8.i,安装电子单体喷油器的线束组件。

    1. 确保线束组件 (5) 和气门机构盖底座 (4) 上的孔清洁且无损坏。 更换任何损坏的部件。

    2. 使用工具 (B) 润滑新的 O 形密封圈 (8)。 将新 O 形密封圈 (8) 安装到线束组件 (5) 上。

    3. 从气门机构盖底座 (4) 内侧,将线束组件 (5) 推入气门机构盖底座 (4) 中。

    4. 确保线束组件 (5) 上位置 (Y) 中的接头安装在垂直面。

    5. 使用工具 (A) 安装卡环 (6)。

    6. 将线束组件 (7) 连接到线束组件 (5)。

    7. 用一个深孔套筒将线束 (5) 连接到电子单体喷油器 (2) 上。 使用工具 (E) 拧紧接头 (1) 至扭矩为 2.4 N·m (21 lb in)

    8. 将新电缆带 (3) 安装到线束组件 (5) 上。

      注: 确保电缆带符合原始设备制造商(OEM)的技术规格。

    9. 重复步骤 8.a 到步骤 8.h 更换其余的线束组件 (5)。

结束:

  1. 安装新喷油管路。 有关正确的步骤,请参阅拆解和组装, "燃油喷油管 - 安装"。

  2. 安装气门机构盖。 请参考拆解和组装, "气门机构盖 - 拆卸和安装"以了解正确步骤。

Caterpillar Information System:

C7.1 Engines Valve Mechanism Cover - Remove and Install
C7.1 Engines Turbocharger - Remove - Turbocharger for Top Mounted Engines
C7.1 Engines Turbocharger - Install - Turbocharger for Top Mounted Engines
C7.1 Engines Turbocharger - Remove - Turbocharger for Side Mounted Engines
C7.1 Engines Turbocharger - Install - Turbocharger for Side Mounted Engines
C7.1 Engines Rocker Shaft and Pushrod - Remove
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies AC Interface PWA (MMS System Cabinet)
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Power Distribution PWA (MMS System Cabinet)
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Parallel Cabinet Interface PWA
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Parallel Cabinet Controller PWA
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Fan Monitor PWA (MMS System Cabinet)
2013/03/22 A New Turbo Kit is Available for Certain 3500B Engines {1052, 1053}
C7.1 Engines Vibration Damper and Pulley - Install
C7.1 Engines Vibration Damper and Pulley - Remove
C7.1 Engines Wastegate Solenoid - Remove and Install
C7.1 Engines Water Pump - Install
C7.1 Engines Water Pump - Remove
C7.1 Engines Water Separator and Fuel Filter (Primary) - Remove and Install
C7.1 Engines Water Temperature Regulator - Remove and Install
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies System I/O PWA (MMS System Cabinet)
C9 Engine Coolant (DEAC) - Change
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies System I/O Daughter PWA (MMS System Cabinet)
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Transformer (T1 to T3)
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies 24V Power Supply (MMS System Cabinet)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.