Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}
- Caterpillar Products:
- All
Set the valve lash on all remanufactured long blocks. The valve lash is not set at the factory. If the valve lash is not set or not set properly, an early hour valve problem may occur.
After installing a remanufactured long block, the valve lash must be set according to the Testing and Adjusting manual. All remanufactured long blocks do have a 0R-8168 Tag attached, alerting the person installing the long block to this issue.
Caterpillar Information System:
2012/10/08 Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}
2012/10/08 Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}
2012/10/24 New Exhaust Valves Are Used in G3500 and G3500B Engines {1105}
C1.5 and C2.2 Industrial Engines Customer Specified Parameters Table
G3520E Generator Set Engines Cylinder Block
C32 Marine Engines Heat Exchanger - Remove and Install
C175-16 Generator Set Engine Engine Oil and Water Pump Drive - Disassemble
2012/10/22 A New Coolant Pressure Sensor Is Used on C175-16 Petroleum Engines {1439, 1439, 191W}
C175-16 Generator Set Engine Engine Oil and Water Pump Drive - Remove and Install
C175-16 Generator Set Engine Engine Oil Filter Housing - Remove and Install
C175-16 Generator Set Engine Engine Oil Pump - Assemble
2012/11/09 A New Canadian Standards Association (CSA) Ignition Harness Is Used by Certain G3406 Engines {1408}
G3520E Generator Set Engines Water Lines
C175-16 Generator Set Engine Engine Oil and Water Pump Drive - Assemble
C175-16 Generator Set Engine Engine Oil Screen - Remove and Install
C175-16 Generator Set Engine Engine Oil Pan - Remove and Install
C1.5 and C2.2 Industrial Engines Customer Specified Parameters Worksheet
2012/10/30 A New Pressure Relief Valve for the Fuel Rail Group Is Used in Certain C9.3 Industrial Engines {1288}
2012/10/11 Later Pre-Chamber Cylinder Heads On Early 3304 Engines Without Drilled Rocker Stands Are Used {1100}
2012/10/15 Later Pre-Chamber Cylinder Heads On Early 3304 Engines Without Drilled Rocker Stands Are Used {1100}
C13, C15, and C18 Tier 4 Final Engines DEF Control Module Power - Test
C13, C15, and C18 Tier 4 Final Engines NOx Conversion Is Low
C13, C15, and C18 Tier 4 Final Engines SCR Catalyst Inlet Temperature Sensor - Test
3500 Generator Sets with Dynamic Gas Blending Fluid Recommendations