2012/10/08 Caterpillar


Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}

Usage:

769C 01X
Caterpillar Products:
  • All
  • Set the valve lash on all remanufactured long blocks. The valve lash is not set at the factory. If the valve lash is not set or not set properly, an early hour valve problem may occur.

    After installing a remanufactured long block, the valve lash must be set according to the Testing and Adjusting manual. All remanufactured long blocks do have a 0R-8168 Tag attached, alerting the person installing the long block to this issue.

    Caterpillar Information System:

    2012/10/24 New Exhaust Valves Are Used in G3500 and G3500B Engines {1105}
    C1.5 and C2.2 Industrial Engines Customer Specified Parameters Table
    G3520E Generator Set Engines Cylinder Block
    C32 Marine Engines Heat Exchanger - Remove and Install
    C175-16 Generator Set Engine Engine Oil and Water Pump Drive - Disassemble
    2012/10/22 A New Coolant Pressure Sensor Is Used on C175-16 Petroleum Engines {1439, 1439, 191W}
    C175-16 Generator Set Engine Engine Oil and Water Pump Drive - Remove and Install
    C175-16 Generator Set Engine Engine Oil Filter Housing - Remove and Install
    C175-16 Generator Set Engine Engine Oil Pump - Assemble
    2012/11/09 A New Canadian Standards Association (CSA) Ignition Harness Is Used by Certain G3406 Engines {1408}
    2012/10/04 A New Unit Injector Wiring Group Is Used on Certain C9.3 Industrial Engines {1290, 1408, 1900}
    C175-16 Generator Set Engine Engine Oil Pump - Disassemble
    2012/10/08 Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}
    2012/10/08 Set Engine Valve Lash After Installing All Remanufactured Long Blocks {1102, 1121, 1123, 1209}
    G3520E Generator Set Engines Water Lines
    C175-16 Generator Set Engine Engine Oil and Water Pump Drive - Assemble
    C175-16 Generator Set Engine Engine Oil Screen - Remove and Install
    C175-16 Generator Set Engine Engine Oil Pan - Remove and Install
    C1.5 and C2.2 Industrial Engines Customer Specified Parameters Worksheet
    2012/10/30 A New Pressure Relief Valve for the Fuel Rail Group Is Used in Certain C9.3 Industrial Engines {1288}
    2012/10/11 Later Pre-Chamber Cylinder Heads On Early 3304 Engines Without Drilled Rocker Stands Are Used {1100}
    2012/10/15 Later Pre-Chamber Cylinder Heads On Early 3304 Engines Without Drilled Rocker Stands Are Used {1100}
    C13, C15, and C18 Tier 4 Final Engines DEF Control Module Power - Test
    C13, C15, and C18 Tier 4 Final Engines NOx Conversion Is Low
    Back to top
    The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
    CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.