Electric Starting Motor
Show/hide table
| |
| Illustration 1 | g03132776 |
Show/hide table
| Specification for 350-8694 Electric Starting Motor Gp | |||
| Item | Qty | Part | Specification Description |
| When the electric starting motor is viewed from the pinion end, the motor rotates in clockwise direction. | |||
| 1 | 1 | 338-3453 Starting Motor Solenoid | Current consumption at 20V and Pull-in winding is 49.3 ± 3.3 amp. Maximum hold-in winding is 6.8 amp. |
| 2 | 2 | 6V-8188 Nut | Torque the ground terminal nut to |
| B | - | - | Clearance between the pinion and the housing is |
Show/hide table
| |
| Illustration 2 | g03132856 |
|
View A-A | |
Show/hide table
| Item | Qty | Part | Specification Description |
| 3 | 1 | - | The switch terminal must be insulated with heat shrink tubing. Do not use molded terminals. |
| Torque to |
|||
| 4 | 1 | - | Torque the ground terminal nut to |
| 5 | 1 | 6V-8188 Nut | A maximum of three cable terminals or wire terminals may be used between the battery terminal nut (4). A maximum of two of the cable terminals may be equal to or greater than 0 AWG. |
| Torque the battery terminal nut to |
|||
| 6 | 1 | 6V-8188 Nut | Torque the motor terminal nut to |
| 7 | 1 | - | Torque the motor frame terminal nut to |
| - | - | - | No load conditions at Speed is 6950 ± 1650 rpm. Current draw is 115 ± 25 amp. Voltage is 23 VDC. |
Caterpillar Information System:
C4.4 Industrial Engine Fuel System Secondary Filter - Replace
C4.4 Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C4.4 Industrial Engine Fuel System Primary Filter (Water Separator) Element - Replace
C6.6 Industrial Engine Engine Crankcase Breather Element - Replace
C9.3 Industrial Engine Turbocharger
C7.1 Industrial Engine Maintenance Interval Schedule
G3500 Engines Cylinder Head
C32 Marine Engines Unit Injector Sleeve - Install
C32 Marine Engines Unit Injector Sleeve - Remove
793F Off-Highway Truck Engine Supplement Turbocharger - Remove and Install - High Altitude
C7.1 Industrial Engine Fuel Filter (In-Line) - Replace
G3500 Engines Cylinder Head
C13, C15, and C18 Tier 4 Final Engines DEF Pressure Is High
C9 On-highway Engines ARD Combustion - Test
C7 and C9 On-Highway Engines Diesel Particulate Filter Collects Excessive Soot
C9 On-highway Engines ARD Failed to Ignite
C9 On-highway Engines ARD Temperature Is Low
C280-16 Petroleum Engine Flywheel
C280-16 Petroleum Engine Flywheel
C7.1 Industrial Engine Engine Oil Level - Check
Handling and Unpacking Instructions for the Uninterruptible Power Supply{4480} Handling and Unpacking Instructions for the Uninterruptible Power Supply{4480}
C7.1 Industrial Engine Engine - Clean
C7.1 Industrial Engine Electrical System
2012/07/31 A New Charging Alternator Group Is Available for Certain C15 and C18 Industrial Engines {1405}