Electric Starting Motor
Show/hide table
图 1 | g03126477 |
Show/hide table
349-6536 电起动马达总成技术规格 | |||
项目 | 数量 | 零件 | 技术规格说明 |
1 | 3 | 6V-8188 螺母 | 拧紧至扭矩为 |
2 | 1 | 338-3453 起动马达电磁阀 | 20V 和 1. 拉动绕组为 49.3 ± 3.3 amp 2. 保持绕组最大为 6.8 amp |
3 | - | - | 拧紧至扭矩为 |
4 | 1 | 4B-2049 螺母 | 拧紧至扭矩为 |
5 | 1 | 4B-2049 螺母 | 开关端子必须用热收缩管绝缘。 不要使用模压端子。
拧紧至扭矩为 |
6 | 1 | 6V-8188 螺母 | 蓄电池端子螺母(5)最多可使用三个电缆或导线端子。 两个端子最高不低于 0 AWG。
拧紧至扭矩为 |
7 | - | - | 拧紧至扭矩为 |
8 | - | - | 拧紧至扭矩为 |
B | - | - | 小齿轮和壳体之间的间隙为 |
- | - | - | 当从小齿轮端观看电起动马达时,马达顺时针旋转。
1. 转速为 6612.0 ± 1887.5 rpm 2. 电流消耗为 100 ± 30 安培 3. 电压为 23 VDC |
Caterpillar Information System:
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Solenoid Valve - Test
Alignment Procedure for Certain G3500 Generator Set Engines with Gearbox {7002} Alignment Procedure for Certain G3500 Generator Set Engines with Gearbox {7002}
C18 Marine Engines Heat Exchanger - Disassemble
C7.1 Industrial Engine Flexible Exhaust Pipe
UPS 250 and UPS 300 Uninterruptible Power Supplies General Hazard Information
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Diagnostic Trouble Codes
C7.1 Engines for Caterpillar Built Machines Alternator
C7.1 Engines for Caterpillar Built Machines Starter Motor
G3500 Engines Camshaft
C13 Tier 4 Final Engines Engine Support (Front)
C13, C15, and C18 Tier 4 Final Engines Water Lines
G3500B Engines Cylinder Block
C9.3 Tier 4 Final Engines Flywheel
UPS 250 and UPS 300 Uninterruptible Power Supplies Device Bus Network
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Event Codes
C13, C15, and C18 Tier 4 Final Engines Exhaust Diffuser Adapter
C18 Marine Engines Heat Exchanger - Assemble
CEM Locomotive Aftertreatment Diesel Exhaust Fluid Nozzle - Inspect/Clean
CEM Locomotive Aftertreatment Exhaust Inlet Nitrogen Oxide Sensor - Replace
2012/07/13 A New Replacement Gas Regulator Is Available for G342, G343, G353, G379, G398, and G399 Engines {1000, 1270}
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Service Tools
CEM Locomotive Aftertreatment Exhaust Outlet Nitrogen Oxide Sensor - Replace
C32 Marine Engines Closed Crankcase Ventilation (CCV) System
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Connector Locations