A New Turbocharger Housing is Used on Certain 3512 Engines {1052, 1065}
- Engine:
- 3512B (S/N: 3ZW1-UP)
Description of Change: The new turbocharger housing mounting flange has been enlarged in order to reduce stress at the turbine inlet joint.
Adaptable To: The new 372-4162 Housing is a direct replacement for the former 294-2939 Housing, which are canceled.
The new turbocharger housing is adaptable back to the first production engine listed above.
Engines must be updated with the 366-9602 Water Temperature Regulator and one of the following flash files prior to installing the new housing:
- 327-2708 Engine Ratings Electronic Software Gp for the ADEM II ECM
- 367-3031 Engine Ratings Electronic Software Gp for the ADEM III ECM
The new parts and former parts are listed in table 1
The only difference between the new turbocharger group and the former turbocharger group is the housing.
Show/hide table
New Parts     | Former Parts     |
372-4161 Turbocharger Gp     | 325-7102 Turbocharger Gp     |
372-4162 Housing     | 294-2939 Housing     |
Caterpillar Information System:
C7.1 Industrial Engine Turbocharger - Inspect - Series Turbochargers
C7.1 Industrial Engine Air Inlet and Exhaust System - Series Turbochargers
3516B Engine for the MT4400D Off-Highway Truck Air Lines - Aftercooler
G3516C and G3516E Gas Engines Engine Oil Cooler Bypass Valve
C18 Marine Engines Housing (Front) - Remove and Install
C18 Marine Engines Gear Group (Front) - Remove and Install
Installation Instruction of Firmware on Network Management Cards{4480, 7620} Installation Instruction of Firmware on Network Management Cards{4480, 7620}
C18 Marine Engines Front Cover - Remove and Install
C18 Marine Engines Crankshaft Front Seal - Remove and Install
C18 Marine Engines Vibration Damper and Pulley - Remove and Install
C18 Marine Engines Flywheel Housing - Remove and Install
C18 Marine Engines Crankshaft Rear Seal - Remove and Install
C7.1 Industrial Engine Turbocharger - Inspect - Single Turbocharger
C7.1 Industrial Engine Air Inlet and Exhaust System - Single Turbocharger
C7.1 Industrial Engine Fuel Injection
3500B Generator Sets Generator Bearing Temperature - Test/Record
C18 Marine Engines Valve Mechanism Cover - Remove and Install
C7.1 Industrial Engine Electronic Control System
C7.1 Industrial Engine Power Sources
C18 Marine Engines Valve Mechanism Cover Base - Remove and Install
G3500 Generator Sets Generator Winding - Test
G3306B Generator Sets Generator Winding Insulation - Test
C18 Marine Engines Rocker Arm and Shaft - Remove and Install
3512C HD SR500 Generator Sets Rotating Rectifier - Inspect/Test