Engine Oil Pan
Show/hide table
Illustration 1 | g03045316 |
Show/hide table
Specification for 241-3292 Oil Pan Gp | |||
Item | Qty | Part | Specification Description |
1 | 3 | 3P-0654 O-Ring Seal | Before assembly, lubricate the bores with green 1P-0808 Multipurpose Grease. |
2 | 2 | 7X-1547 O-Ring Seal | Before assembly, lubricate the bores with green 1P-0808 Multipurpose Grease. |
3 | 1 | 7E-2630 Oil Pan Gasket | As required, apply clear Loctite RTV silicone, permetex number 2, or red Loctite High Tack GS S to the oil pan gasket. |
4 | 2 | 0S-1590 Bolt | In order to prevent stress on the tube assembly (6), use the following tightening procedure during assembly:
1. Tighten the bolt (5) to 2. Tighten the bolt (4) to |
5 | 2 | 0S-1588 Bolt | |
7 | - | - | As required, apply clear Loctite RTV silicone, permetex number 2, or red Loctite High Tack GS S to the connecting joint of the flywheel housing group and the cylinder block. |
8 | - | - | As required, apply clear Loctite RTV silicone, permetex number 2, or red Loctite High Tack GS S to the connecting joint of the cylinder block and the front housing group. |
Caterpillar Information System:
2012/05/23 Activation Password Is Now Required For Touchscreens Of Uninterruptible Power Supplies {7451}
G3500 Generator Sets Fluid Recommendations
3512C and 3516C Marine Propulsion Engines Speed Control - Test
2012/05/21 New Clamping for the Jacket Water Bypass Tube on Certain 3500 Engines {1380, 7553}
C18 Marine Engines Inlet and Exhaust Valve Seat Inserts - Remove and Install
C18 Marine Engines Inlet and Exhaust Valve Guides - Remove and Install
2012/05/21 Viewing the Electronic Thermostat Position via ET on C175 Engines {135V, 7610}
C18 Marine Engines Inlet and Exhaust Valves - Remove and Install
C18 Marine Engines Inlet and Exhaust Valve Springs - Remove and Install
G3516C and G3516E Gas Engines Camshaft Bearing Position
C18 Marine Engines Turbocharger - Remove and Install
C18 Marine Engines Electronic Unit Injector Sleeve - Remove and Install
C7.1 Industrial Engine Product Description - Engine and Aftertreatment
G3516C and G3516E Gas Engines Water Pump
G3500 Engines Engine Oil Filter
3516B Engine for the MT4400D Off-Highway Truck Flywheel
G3500 Generator Sets Coolant (DEAC) - Change
C9.3 Tier 4 Final Engines Sensor Signal (Analog, Active) - Test
G3500 Generator Sets Coolant (NGEC) - Change
3516B Engine for the MT4400D Off-Highway Truck Auxiliary Drive (Lower Left Hand)
14M Series 3 Motor Grader Brakes, Indicators and Gauges - Test
G3500 Generator Sets Coolant Level - Check
2012/05/21 Cat® Electronic Technician (Cat® ET) Improved for Configuring of Annunciator Alarm Module on Certain Cat® Products {0785, 7400}
C18 Marine Engines Engine Oil Filter Base - Remove and Install