Monitoring System - Engine Warning Indicators
Show/hide table
| Table for Warning Indicators | |||||
|---|---|---|---|---|---|
| Warning Indicator | Shutdown Indicator | Indicator State | Description of the Indication | Engine Status | Operator Action |
| ON | ON | Indicator Check | Keyswitch in the ON position all Indicators should illuminate for 2 seconds. | Power ON, Indicator check
Engine is not operating. |
If any of the Indicators will not illuminate during the Indicator check, the fault must be investigated immediately. If any Indicator stay illuminated or flash, the fault must be investigated immediately. |
The aftertreatment Indicators will also be checked during Indicator check. |
|||||
| OFF | OFF | No Fault | - | Engine operating normally. | None |
| Level 1 | |||||
| ON (Solid) | OFF | Level 1 | An active diagnostic code is present. | The engine is operating, but one or more diagnostic codes are present. | As soon as possible the diagnostic code should be investigated. |
| Level 2 | |||||
| Flashing | OFF | Level 2 | The ECM has detected an abnormal condition. | If enabled, the engine will be derated. | Stop the engine.
Investigate the fault. |
| Level 3 | |||||
| Flashing | ON | Level 3 | Engine condition is abnormal. | The engine will automatically shut down.
If shut down is not enabled, the engine can operate until damage is coursed. |
Stop engine immediately.
Investigate the fault. |
Caterpillar Information System:
3500 Generator Sets Coolant Temperature Regulator - Replace
C3.4B Industrial Engine Stopping the Engine
CG137-08 and CG137-12 Generator Sets Engine Oil Pump
CG137-08 and CG137-12 Generator Sets Exhaust Bypass Valve
C27 Generator Set Control Panel - Inspect/Test
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission Planetary - Assemble
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission Planetary - Disassemble
3500 Generator Sets Coolant Level - Check
349F and 352F Excavators Hydraulic System Automatic Travel Speed Control - Test
3500 Generator Sets Coolant (ELC) - Change
3500 Generator Sets Coolant (DEAC) - Change
3512, 3508 and 3516 Generator Sets Refill Capacities
C27 Generator Set Manual Stop Procedure
3516C Generator Sets Before Starting Engine
XQ400 Power Module Maintenance Recommendations
Using the U5MK1110 Ampseal Connector Kit for Wiring Harness Repairs on Perkins Engines{0374, 0599, 0701, 0709} Using the U5MK1110 Ampseal Connector Kit for Wiring Harness Repairs on Perkins Engines{0374, 0599, 0701, 0709}
Idler/Roller Assembly Machine{0374, 0599, 0729, 4159, 4180} Idler/Roller Assembly Machine{0374, 0599, 0729, 4159, 4180}
Base-Mounted Recirculating Parts Washers{0374, 0599, 0680, 0699, 0700} Base-Mounted Recirculating Parts Washers{0374, 0599, 0680, 0699, 0700}
C3.4B Engines Inlet Air Is Restricted
2011/10/13 Service Replacement Bolts and Seal Washers Are Available for the High-Pressure Fuel Pump on C175-16 Engines {1251, 1290, 7553}
3516C Generator Set Engines Coolant Temperature Is Low
3516C Generator Set Engines Oil Pressure Is Low
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ Symptom Troubleshooting
3516C Generator Set Engines Coolant Temperature Is High