C11, C13, and C15 On-highway Engines Caterpillar


Maintenance Interval Schedule - C11 and C13 Engines with Optional Shallow Oil Sumps

Usage:

C13 JAM
在进行任何操作或维护步骤之前,确保已阅读并理解所有的安全信息、警告和说明。 用户应执行包含以下步骤在内的所有保养: 所有调整 、使用正确的润滑剂、油液、滤清器 ,以及由于正常磨损和老化而进行新部件的安装 。 如果不遵守正确的保养周期和步骤,产品的性能会降低。 如果不遵守正确的保养周期和步骤,可能会加快部件磨损。

注: 使用以下最先到期的一项以确定保养周期: 耗油量 、工作小时数 、里程 和日历时间 。 在进行每个后续周期的保养之前,必须先进行前一个周期的所有保养。

在恶劣作业条件下工作的产品可能需要更频密的保养。

需要时即进行的保养

蓄电池 - 更换
蓄电池或蓄电池电缆 - 断开
冷却液 - 更换
冷却液延长剂(ELC)- 添加
冷却剂样品 (一级) – 取样
冷却剂样品 (二级) – 取样
发动机空气滤清器滤芯(单滤芯) - 检查/清洁/更换
发动机机油油位尺 - 校准
燃油系统 - 充油

每天的保养

冷却液液位 - 检查
发动机空气滤清器保养指示器 - 检查
发动机机油油位 - 检查
燃油系统油水分离器 - 检查/排放
围绕检查

1级预防性保养(PM Level 1) - 每 24 000 km (15 000 miles)或每 5700 L (1500 US gal)燃油消耗量或每400个工作小时或每6个月

软管和卡箍 - 检查/更换

每32000 公里(20000 英里) 或9464 升(2500 美加仑)的燃油或300工作小时数

发动机机油油样 - 采样
发动机机油和滤清器 - 更换

PM1级 - 每48 000公里(30 000英里)或15520升(4100美加仑)燃油或500工作小时数

空压机滤清器 - 清洁/更换
空气切断阀 - 测试
交流发电机 - 检查
蓄电池电解液液位 - 检查
皮带张紧器 - 检查
皮带 - 检查/调整/更换
冷却系统冷却液补充添加剂(SCA) - 测试/添加
发动机曲轴箱呼吸器 - 清洗
燃油系统粗滤器 - 更换
燃油系统细滤清器 - 更换
燃油箱中的水和沉渣 - 排放
接地双头螺柱 - 检查/清洁/紧固
软管和卡箍 - 检查/更换

在24 000至96 000公里(15 000至60 000英里)之间

发动机气门间隙-检查
喷油器 - 检查
ÆøÃÅÖ´ÐÐÆ÷ - ¼ì²é

预防性保养(PM)2级 - 每 320 000公里 (200 000英里)125 000升 (33 000美加仑)燃油或4000工作小时数或2年

后冷器芯 - 清洁/测试
冷却液温度调节器 - 更换
风扇传动轴承 - 润滑
散热器 - 清洁

预防性保养(PM)3级 - 每 483 000公里 (300 000英里)190 000升 (50 000美加仑)燃油或6000工作小时数或3年

空气压缩机 - 检查
曲轴减振器 - 检查
发动机 - 清洁
发动机气门间隙-检查
喷油器 - 检查
涡轮增压器 - 检查
ÆøÃÅÖ´ÐÐÆ÷ - ¼ì²é

Caterpillar Information System:

C11, C13, and C15 On-highway Engines Maintenance Interval Schedule - C11 , C13 , and C15 Engines with Standard (Deep) Oil Sumps
345B Excavator Machine System Specifications Track Roller Mounting
Repair Procedure for Damaged Harness Wiring {1408} Repair Procedure for Damaged Harness Wiring {1408}
CG137-08 and CG137-12 Industrial Engines Speed/Timing (Secondary) - Test
2011/07/14 Glow Plugs on Certain C6.6 Engines {1412}
2011/09/12 A New Gasket and a New Spacer Plate are Now Used on Certain Reman 3500 Engines {1100, 1201, 7555}
G3406 Engine Spark Plugs - Inspect/Adjust/Replace
CG137-08 and CG137-12 Engines Gas Pressure Regulator - Remove and Install
CG137-08 and CG137-12 Industrial Engines Speed/Timing (Primary) - Test
G3406 Engine Fuel Filter Differential Pressure - Check
2011/10/06 Warning Film Is Available for the High Pressure Fuel Pump on C175-16 Engines {1251, 1290, 7405}
3500C Marine Engines Gear Group (Front)
C11, C13, and C15 On-highway Engines Maintenance Interval Schedule - C11 and C13 Engines with 500 HP Field Up-Rates and 525 HP RV Ratings with Standard (Deep) Oil Sumps
C11, C13, and C15 On-highway Engines Maintenance Interval Schedule - C11 and C13 Engines with 500 HP Field Up-Rates and 525 HP RV Ratings with Optional (Shallow) Oil Sumps
3500B Engines Engine Mount
345B Series II Excavator Machine System Specifications Bucket Cylinder
3516C Generator Set Engines Gear Group (Rear)
G3512 Gas Engine Flywheel
3516C Generator Set Engines Flywheel Housing
3512B and 3512C Petroleum Generator Set Engines Flywheel Housing Cover
3500C Marine Engines Vibration Damper Guard
CG137-08 and CG137-12 Engines Rotary Actuator (Carburetor) - Remove and Install - G3412B
CG137-08 and CG137-12 Engines Rotary Actuator (Gas Pressure Regulator) - Remove and Install
CG137-08 and CG137-12 Engines Carburetor - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.