Window Wiper and Wiper Motor (Rear) - Remove and Install
- Disconnect hose (3). Open cover (1) and remove nut (2) and the lockwasher. Remove wiper assembly (4).
Show/hide table
Illustration 2 g02453152 - Remove the bolts and washers and slightly open up cover (5).
Show/hide table
Illustration 3 g02453323 Show/hide tableIllustration 4 g02453341 - Cut cable strap (7) and disconnect harness assembly (6).
- Remove cover (5) and rear wiper motor (8) as one unit.
Show/hide table
Illustration 5 g02453349 - Remove cap (13), nut (11), washer (10), and washer (9). Remove nut (12). Remove rear wiper motor (8) from cover (5).
Show/hide table
Illustration 1 | g02448924 |
- Install rear wiper motor (8) in the reverse order of removal.
- Tighten nut (12) to a torque of
7.5 ± 0.5 N·m (66.38 ± 4.43 lb in) . - Tighten nut (11) to a torque of
9 ± 1 N·m (80 ± 9 lb in) . - Tighten nut (2) to a torque of
23 ± 1 N·m (204 ± 9 lb in) . Wait a minimum of 0.5 hour and torque nut (2) again to a torque of23 ± 1 N·m (204 ± 9 lb in) .
- Tighten nut (12) to a torque of
Caterpillar Information System:
D9T Track-Type Tractor Power Train Brake Pressure - Test
C9.3 Marine Generator Set Engines Cooling System - Inspect
C13 Industrial Engine Engine Air Cleaner Element (Single Element/Canister Type) - Clean/Replace - If Equipped
C7.1 Industrial Engine Engine Air Cleaner Element (Dual Element/Canister Type) - Clean/Replace - If Equipped
D7E Track-Type Tractor Hydraulic, HVAC and Electrical Systems Piston Pump (Steering Charge and Pilot Pressure) - Test and Adjust
D9T Track-Type Tractor Power Train Transmission Clutch Pressure - Test
374F Excavator Cab Door Latch - Inspect/Adjust/Replace
D3K2, D4K2 and D5K2 Track-Type Tractors Declaration of Conformity
D3K2, D4K2 and D5K2 Track-Type Tractors Plate Locations and Film Locations
D7E Track-Type Tractor Hydraulic, HVAC and Electrical Systems Piston Pump (Steering) - Test and Adjust
C11 and C13 Engines for Caterpillar Built Machines Ether Injection System - Test
Updated Diagnostic Information Is Available for Certain C7 and C9 ACERT Engines That Are Equipped With Hydraulic Electronic Unit Injectors (HEUI) Fuel Systems{1126, 1250, 1251, 1290, 1714} Updated Diagnostic Information Is Available for Certain C7 and C9 ACERT Engines That Are Equipped With Hydraulic Electronic Unit Injectors (HEUI) Fuel Systems{1126, 1250, 1251, 1290, 1714}
541 Series 2 and 552 Series 2 Track Feller Bunchers Fire Extinguisher Location
966M and 972M Wheel Loaders Operation
966M and 972M Wheel Loaders Work Tools
966M and 972M Wheel Loaders Operator Station
D7E Track-Type Tractor Hydraulic, HVAC and Electrical Systems Accumulator (Pilot) - Test and Charge
966M and 972M Wheel Loaders Stopping the Machine
PL83 and PL87 Pipelayer Systems Track - Adjust
950K and 962K Wheel Loaders Automatic Lubrication Grease Tank - Fill - Autolube - If Equipped
2011/10/07 Improved Angle Cylinder Now Used on Certain D6N Track Type Tractors {5101}
C4.4 Industrial Engine Atmospheric Pressure Sensor
C4.4 Industrial Engine Electronic Control Module
950K and 962K Wheel Loaders Radiator Core - Clean