Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Differential Pressure
拆卸步骤
开始:
- 拆下烟气处理总成。
- 断开电缆带后断开线束组件 (3) 。 拆下螺栓 (1) 后拆下压差传感器 (2) 。 拆下两个 O 形密封圈（未显示）。
Show/hide table
 | |
| 图 1 | g02348357 |
安装步骤
- 按相反顺序安装压差传感器 (2) 。
- 拧紧螺栓 (1) ，使其扭矩达到 10 ± 2 N·m (89 ± 18 lb in)。
Caterpillar Information System:
2010/12/08 An Improvement has been Made to Reduce the Amount of Radial Play of the Front Linkage Pin on Certain Excavators {6501, 6502, 6513}
312E, 312F, 313F, 316E, 316F, 318E, 318F, 320E, 320F, 323E, 323F, 324E, 325F, 326F, 329E, 329F, 330F, 335F, 336E, 336F, 340F, 349E, 349F, 352F, 374F and 390F Excavators and 336E MHPU and 349E MHPU Mobile Hydraulic Power Units Air Conditioning and Hea Pressure Switch (Refrigerant Pressure Cutoff)
C15 and C18 Industrial Engines Pistons and Connecting Rods - Remove and Install
C27 and C32 Engines Exhaust Elbow - Remove and Install - Clean Emissions Module Inlet
3516B Marine Auxiliary Engine Cat Data Link - Test
C3.4B Industrial Engine Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
C7.1 (Mech) Industrial Engine Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
C7.1 (Mech) Industrial Engine Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
XQP150 Rental Generator Set Belts - Inspect/Adjust/Replace
C27 and C32 Engines for Caterpillar Built Machines Piston and Rings
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Solenoid Valve (Proportional Reducing) - Calibrate - Flow Limit Valves
C13 Tier 4 Final Engines Air Cleaner
C15 and C18 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Outlet Pressure
Installing an Automatic Stationary Regeneration Switch on Certain On-highway Engines{108F, 7332} Installing an Automatic Stationary Regeneration Switch on Certain On-highway Engines{108F, 7332}
C27 Petroleum Engine Inlet and Exhaust Valve Springs - Remove and Install
C4.4 Industrial Engine Aftercooler Core - Inspect
CG137-08 and CG137-12 Industrial Engines Electronic Control System Components
CG137-08 and CG137-12 Industrial Engines Electrical Connectors
2010/12/20 A New Flange Is Used for the Water Lines Group on C175-16 Generator Set Engines {1355, 1380, 1393}
3516B Marine Auxiliary Engine Speed/Timing - Test
CG137-08 and CG137-12 Industrial Engines Electronic Control Module (ECM)
320E and 323E Excavators Hydraulic System Final Drive
C9 On-highway Engines Air Compressor - Check
C9 On-highway Engines Belt Tensioner - Check - If Equipped