Inlet Manifold - Remove and Install
Start By:
- Remove the air inlet elbow.
- Remove the exhaust gas valve.
- Disconnect harness assemblies (1) and (2).
- Remove brackets (3) and (4).
- Remove bolts (5) and position wiring harness (6) out of the way.
Show/hide table
Illustration 2 g02249733 Note: If necessary remove center clamp (8).
- Remove bolts (7) and position clamps (8) out of the way.
Show/hide table
Illustration 3 g02251254 Note: Bolts (11) are inside air inlet manifold (10).
- Remove bolts (9) and (11).
- Remove air inlet manifold (10).
- Repeat Steps 1 through 6 for the other side.
Show/hide table
| |
| Illustration 1 | g02249475 |
- Install air inlet manifold (10) in the reverse order of removal.
- Install bolt (9) before installing the air inlet manifold into position.
Show/hide table
Illustration 4 g02251975
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Air Cleaner
C7.1 Industrial Engine Turbocharger - Inspect - Series Turbochargers
C3.4B Engines Intake Manifold Air Temperature Is High
C3.4B Engines Intake Manifold Air Pressure Is Low
Incorrect Torquing on Water Pump Groups for Certain C-10 and C-12 Engines{1361, 7553} Incorrect Torquing on Water Pump Groups for Certain C-10 and C-12 Engines{1361, 7553}
C15 and C18 Engines for Caterpillar Built Machines Alternator and Regulator
Packaging Instructions for a Diesel Particulate Filter (DPF) Core Return for Certain Non-Road Applications{108F} Packaging Instructions for a Diesel Particulate Filter (DPF) Core Return for Certain Non-Road Applications{108F}
C3.4B Engines Intake Manifold Air Pressure Is High
C3.4B Engines Fuel Rail Pressure Problem
Instructions for Weld Finish of the "K" Series Adapters Installed on Large Wheel Loader Buckets{0679, 6101, 6102, 6104, 6805} Instructions for Weld Finish of the "K" Series Adapters Installed on Large Wheel Loader Buckets{0679, 6101, 6102, 6104, 6805}
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System General Information
XQ Auto Paralleling Before Starting Engine
3512C HD Locomotive Engine Cooling System Coolant (ELC) - Change
3512C HD Locomotive Engine Crankshaft Vibration Damper - Inspect
3512C HD Locomotive Engine Engine Air Cleaner Element (Dual Element) - Clean/Replace
3512C HD Locomotive Engine Engine Oil and Filter - Change
3512C HD Locomotive Engine Engine Valve Lash - Inspect/Adjust
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C6.6 Industrial Engine Fuel Filter Base - Remove and Install - Twin Secondary Fuel Filter
C27 and C32 Industrial and Petroleum Engines Turbocharger
C11 and C13 Engines Engine Oil Cooler
New Control Panel for C4.4 Marine Generator Set{4490, 7490} New Control Panel for C4.4 Marine Generator Set{4490, 7490}
2010/09/10 Changes to the Usage and Cleaning of the Contamination Monitor Group {0784, 5050}
2010/10/01 Changes to the Usage and Cleaning of the Contamination Monitor Group {0784, 5050}