XQ Auto Paralleling Caterpillar

Engine Starting

Usage:

PMG3516 KAD

If a warning tag is attached to the engine start switch or to the controls, DO NOT start the engine or move the controls. Consult with the person that attached the warning tag before the engine is started.

Do not start the engine when anyone is working on the generator set. Do not start the engine when anyone is working near the generator set.

All protective guards and all protective covers must be installed if the engine is started in order to perform service procedures. To help prevent an accident that is caused by parts in rotation, work around the parts carefully.

Start the engine from the EMCP 3 panel and/or the local start/stop switch that is located on the Load Control panel. Refer to Operation and Maintenance Manual, SEBU8514, "Modes of Operation" for detail.

Engine exhaust contains products of combustion which can be harmful to your health. If the power module is started in an enclosed area, vent the engine exhaust to the outside. Always operate the power module in order to ensure that proper ventilation is achieved.

Caterpillar Information System:

XQ Auto Paralleling Fire Prevention and Explosion Prevention

XQ Auto Paralleling Engine Stopping

3516C Locomotive Engines Selective Catalytic Reduction Module - Assemble

C27 and C32 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install

C3.4B Engines Engine Overspeeds

C27 and C32 Engines for Caterpillar Built Machines Air Inlet Elbow - Remove and Install

312F and 313F Excavators Fumes Disposal Filter Element - Replace

Replacing the High Pressure Fuel Pump on Certain C7 and C9 Engines{1251, 1714} Replacing the High Pressure Fuel Pump on Certain C7 and C9 Engines{1251, 1714}

C3.4B Engines Engine Has Early Wear

320E and 323E Excavators Fuel System Primary Filter (Water Separator) Element - Replace

C27 and C32 Industrial Engines Exhaust Gas Valve (NRS) - Remove and Install

312F and 313F Excavators Engine Oil Level - Check

XQ Auto Paralleling General Hazard Information

XQ Auto Paralleling Burn Prevention

XQ Auto Paralleling Before Starting Engine

349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System General Information

Instructions for Weld Finish of the "K" Series Adapters Installed on Large Wheel Loader Buckets{0679, 6101, 6102, 6104, 6805} Instructions for Weld Finish of the "K" Series Adapters Installed on Large Wheel Loader Buckets{0679, 6101, 6102, 6104, 6805}

C3.4B Engines Fuel Rail Pressure Problem

C3.4B Engines Intake Manifold Air Pressure Is High

Packaging Instructions for a Diesel Particulate Filter (DPF) Core Return for Certain Non-Road Applications{108F} Packaging Instructions for a Diesel Particulate Filter (DPF) Core Return for Certain Non-Road Applications{108F}

C15 and C18 Engines for Caterpillar Built Machines Alternator and Regulator

Incorrect Torquing on Water Pump Groups for Certain C-10 and C-12 Engines{1361, 7553} Incorrect Torquing on Water Pump Groups for Certain C-10 and C-12 Engines{1361, 7553}

C3.4B Engines Intake Manifold Air Pressure Is Low

C3.4B Engines Intake Manifold Air Temperature Is High