XQ Auto Paralleling Caterpillar


Handling

Usage:

PMG3516 KAD

------ DANGER! ------

Improper handling of the equipment may result in personal injury or death or damage to the equipment. Handle with care and move the equipment slowly. Ensure that the equipment is not handled in a rough manner. Bodily contact with electrical potential will cause personal injury or death.


  1. After the power module has been inspected, determine whether the shipment is complete. Determine whether the shipment is correct.

  1. Handle the power module with care. Rough handling may damage internal components and to external components.

  1. Avoid scratching or marring of the finish of the power module container. Imperfections in the finish will allow rusting to begin.

  1. When you ship the power module, the generator circuit breaker must be in the CONNECTED position.

Caterpillar Information System:

XQ Auto Paralleling Installation
XQ Auto Paralleling Initial Startup Procedure
3516C Locomotive Engines Selective Catalytic Reduction Module - Disassemble
3512C Oil Well Service Engines Product Lifting
120 and 120 AWD Motor Grader Drawbar Ball and Socket End Play - Check/Adjust
2010/12/06 A New Injector Wiring Harness Kit Is Available to Make Repairs on Certain Commercial Engines {1254, 1290, 1408}
2011/01/10 A New Wiring Harness Kit Is Available in Order to Make Repairs on Certain Truck Engines {1254, 1290, 1408}
3512C Oil Well Service Engines Safety Messages
120 and 120 AWD Motor Grader Drawbar Ball and Socket - Lubricate
120 and 120 AWD Motor Grader Axle Oscillation Bearings - Lubricate
C27 and C32 Industrial Engines Coolant Temperature Sensor - Remove and Install
120 and 120 AWD Motor Grader Scarifier Digging Angle - If Equipped
XQ Auto Paralleling Generator Load Connections
XQ Auto Paralleling Default Settings for Mode of Operation
XQ Auto Paralleling Default Settings for Generator Paralleling Control
XQ Auto Paralleling Default Settings for Engine Electronic Control Module
XQ Auto Paralleling Default Settings for Electronic Modular Control Panel
XQ Auto Paralleling Storage
XQ Auto Paralleling Default Settings for Discrete Input/Output Module
XQ Auto Paralleling Receiving Inspection
XQ Auto Paralleling Default Settings for Cat Digital Voltage Regulator
XQ Auto Paralleling Advanced Control Jumpers
XQ Auto Paralleling Power Module Controls - Check
G3306B Gas Engines Fuel Filter
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.