C13, C15, and C18 Tier 4 Final Engines Caterpillar


Electric Starting Motor

Usage:

826K 232


图 1g02996056

表 1
293-4853 电起动马达总成技术规格 
项目  数量  零件  技术规格说明 
蓄电池端子。
螺母之间的电缆或导线端子数目最大应为 3。
两个电缆端子的最大值可大于 0 AWG。
蓄电池端子上的螺母的最终安装扭矩为 24 ± 2 N·m (212 ± 18 lb in)。 
电磁阀安装螺母的最终安装扭矩为 8.75 ± 1.05 N·m (77.44 ± 9.29 lb in)。 
开关端子:
将开关端子连接至起动继电器开关上。
无需其它连接。
开关端子上的螺母的最终安装扭矩为 2.15 ± 0.25 mm (0.08 ± 0.01 in)。 
接地端子上的螺母的最终安装扭矩为 24 ± 2 N·m (212 ± 18 lb in)。 
小齿轮啮合时的距离为 69.9 mm (2.75 in)。 
小齿轮分开时的距离为 47.5 ± 2.2 mm (1.87 ± 0.09 in)。 
从小齿轮端看的转动方向为顺时针。
工作电压为 24 VDC。
工作温度范围为 −32 至 +120° C (−26 至 248° F)。 
20 °C (68 °F) 时的无负载性能:
转速为 4059 ± 470 rpm。
电流为 142 ± 30 amp。
电压为 24 VDC。 

Caterpillar Information System:

C27 Generator Set Engines Air Inlet and Exhaust System - Inspect
C9.3 Engines for Caterpillar Built Machines Pressure Sensor (DPF) - Remove and Install
C13 Industrial Engines Electric Starting Motor
C4.4 (Mech) Marine Generator Set MCS-3 Fuel System Secondary Filter - Replace
C4.4 (Mech) Marine Generator Set MCS-3 Fuel System Primary Filter (Water Separator) Element - Replace - if Equipped
C4.4 (Mech) Marine Generator Set MCS-3 Engine Speed/Timing Sensor - Clean/Inspect
C4.4 (Mech) Marine Generator Set MCS-3 Fuel System - Prime - Duplex Fuel Filter if Equipped
C4.4 (Mech) Marine Generator Set MCS-3 Engine Oil and Filter - Change - Duplex Oil Filters
C4.4 (Mech) Marine Generator Set MCS-3 Engine Oil and Filter - Change - Single Oil Filter
C4.4 Industrial Engine Fuel System - Prime
C4.4 (Mech) Marine Generator Set MCS-3 Generator Lead Connections
2010/04/30 A Rework Procedure Improves the Seal Assembly Performance in Hydraulic Cylinders on Cat Products {7562}
C27 and C32 Tier 4 Engines Component Location
317-7492 Wireless Radio{7338} 317-7492 Wireless Radio{7338}
348-5430 Multi-Tool Gp 2 {0709, 0769, 0785} 348-5430 Multi-Tool Gp 2 {0709, 0769, 0785}
C9.3 Engines for Caterpillar Built Machines Pressure Sensor (ARD Combustion Air) - Remove and Install
C7.1 Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C4.4 Industrial Engine Accessory Drive
C4.4 Industrial Engine Accessory Drive - SAE "B"
525D, 535D, 545D, 555D Wheel Skidder Fuel System Primary Filter (Water Separator) Element - Replace
C4.4 Industrial Engine Air Compressor - Twin Cylinder Compressor
C4.4 Industrial Engine Air Compressor - Single Cylinder
C175-16 PETROLEUM ENGINES Air Shutoff - Remove and Install
C4.4 Industrial Engine Exhaust Sensor and Lines (NRS)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.