General Information
Show/hide table
 | |
| Illustration 1 | g02148292 |
The auto paralleling system uses a controller that is developed for Caterpillar power modules. The generator uses a main circuit breaker (GCB) that is mounted on the generator. The paralleling control is provided by the generator paralleling controller (GPC). The GPC provides synchronizing, load share, and utility base load control for the generator set.
Show/hide table
 | |
| Illustration 2 | g02148221 |
Typical 480V One Line | |
Caterpillar Information System:
XQ Auto Paralleling Electrical System
XQ Auto Paralleling Safety Messages
2010/04/16 A New Strainer Is Used on the Air Starting Systems of Certain C18 and C32 Engines {1451}
2010/06/10 Procedure To Check Crankshaft Deflection in 3600 and C280 Engines {1202}
C9.3 Marine Engines Fastener Group (Vibration Damper)
797F Off-Highway Truck Power Train Tire and Rim (Rear) - Remove and Install
797F and 797F XQ Off-Highway Trucks Machine Systems Tire and Rim (Front) - Remove and Install
C4.4 (Mech) Marine Generator Set MCS-3 Safety Messages
C7.1 Marine Generator Set Generator Winding Insulation - Test
C4.4 (Mech) Marine Generator Set MCS-3 Declaration of Conformity
2010/04/22 Improvement Made to the Harness in the Right-Hand Side Cab Console for Certain Excavators {1408}
C4.4 (Mech) Marine Generator Set MCS-3 Sensors and Electrical Components - MCS Switches and Alarms
XQ Auto Paralleling Component Descriptions
XQ Auto Paralleling Component Location
XQ Auto Paralleling Reference Material
XQ Auto Paralleling Fuel System
XQ Auto Paralleling Single Unit Mode
XQ Auto Paralleling Island Paralleling Mode
XQ Auto Paralleling Utility Paralleling Mode
XQ Auto Paralleling Default Settings for Utility Multifunction Relay
XQ Auto Paralleling Base Load Potentiometer Settings
XQ Auto Paralleling Operator Controls
XQ Auto Paralleling Abbreviations
XQ Auto Paralleling Glossary