Fuel Priming Pump and Primary Fuel Filter - With Water Separator
Show/hide table
 | |
| 图 1 | g03368558 |
Show/hide table
| 348-6959 燃油充油泵和粗滤器总成 和 348-6960 燃油充油泵和油水分离器 的技术规格 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| 1 | 1 | 284-8381 拨动开关 | 拧紧扭矩至 2.2 ± 0.1 N·m (19.5 ± 1.0 lb in)。 |
| 2 | 1 | 212-9580 油水分离器和燃油滤清器总成 | 拧紧油水分离器和燃油滤清器总成，直至它们正确落座在燃油注油泵总成中。 再拧紧 3/4 圈。 |
| 3 | 1 | 343-5527 油杯 | 使用以下步骤组装油杯： 1. 从滤清器组件的底部拆下盖。 2. 从盖底部拆下密封件。 弃置盖。 3. 利用干净的发动机机油润滑密封件。 4. 将密封件安装到油杯组件的凹槽上。 5. 将油杯组件安装到滤清器组件底部的螺纹上。 6. 将油杯组件拧紧至扭矩为 10 N·m (7 lb ft)。 |
Show/hide table
 | |
| 图 2 | g03368582 |
Show/hide table
| 项目 | 数量 | 零件 | 技术规格说明 |
| 4 | 1 | - | 将螺母拧紧至扭矩为 6.5 ± 0.5 N·m (57.5 ± 4.4 lb in)。 |
| 5 | 1 | - | 将阀体芯拧紧至扭矩为 28 ± 3 N·m (248 ± 27 lb in)。 |
| 6 | 1 | 9S-8002 O 形密封圈塞 | 拧紧至扭矩为 11 ± 2 N·m (97 ± 18 lb in)。 |
| 7 | 2 | 179-7267 塞 | 拧紧至扭矩为 95 ± 10 N·m (70 ± 7 lb ft)。 |
| 8 | 1 | 327-8044 单向阀总成 | 拧紧至扭矩为 28 ± 3 N·m (248 ± 27 lb in)。 |
| 9 | 1 | 9S-4167 空心螺柱 | 将红色 Loctite 271 涂覆到长度（E）上，如图 2 中所示 拧紧至扭矩为 70 ± 15 N·m (52 ± 11 lb ft)。 |
| 10 | 1 | 328-8351 接头 | 拧紧至扭矩为 13.5 ± 0.5 N·m (119.5 ± 4.4 lb in)。 |
| 11 | 2 | 6D-5801 锁紧螺母 | 拧紧至扭矩为 1.7 ± 0.4 N·m (15.0 ± 3.5 lb in)。 |
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
2010/03/05 A New Spark Plug Is Used on some G3500 Generator Set Engines {1550, 1555}
G3520E Generator Set Engines Piston and Rings
C11 and C13 Engines Muffler
C11 and C13 Engines Muffler
C15 and C18 Engines for Caterpillar Built Machines Temperature Sensor (NOx Reduction System)
C15 and C18 Engines for Caterpillar Built Machines Pressure Sensor (NOx Reduction System)
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Cooler - Remove and Install
C15 Engine for Caterpillar Built Machines Engine Design
797F Off-Highway Truck Power Train Gear Motor (Rear Axle Lubrication) - Assemble
797F Off-Highway Truck Power Train Gear Motor (Rear Axle Lubrication) - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Camshaft
C13 Industrial Engines Fuel Priming Pump and Primary Fuel Filter - With Water Separator
C13 Industrial Engines Fuel Priming Pump and Primary Fuel Filter - With Water Separator
3516C Locomotive Engine Emergency Stopping
793F Off-Highway Truck Engine Supplement Engine Oil Cooler - Remove and Install
Procedure for Improving the Ground System{4459, 7423} Procedure for Improving the Ground System{4459, 7423}
C175-16 Locomotive Engine Temperature Sensor - Exhaust Temperature
C175-16 Locomotive Engine Temperature Sensor - Engine Coolant
G3520E Generator Set Engines Accessory Drive
349F and 352F Excavators Fuel Tank Shutoff and Drain Control
TH55FT-E70 and TH55FT-E90 Transmissions Transmission Cooling System
C13 Industrial Engines Electronic Unit Injector Wiring
TH48-E80 Petroleum Transmission S·O·S Information