C13, C15, and C18 Tier 4 Final Engines Caterpillar


Speed/Timing Sensor

Usage:

826K 232

凸轮轴位置传感器




图 1g03349547

表 1
239-2397 速度传感器总成 的技术规格    
项目     数量     零件     技术规格说明    
1     -     -     确保支架安装方向与图 1 中所示方向一致。    
2     -     -     传感器的工作温度为
−40° C 至 120° C (−40° F 至 248° F)。    
-     -     -     在安装之前,用清洁的发动机机油润滑一下转速传感器密封件。    
-     -     -     在拧紧螺栓之前确保转速传感器已经安装到位。    

曲轴位置传感器




图 2g03349548

表 2
230-7149 速度传感器总成 的技术规格    
项目     数量     零件     技术规格说明    
1     -     -     确保支架安装方向与图 2 中所示方向一致。    
2     -     -     传感器的工作温度为
−40° C 至 120° C (−40° F 至 248° F)。    
-     -     -     在安装之前,用清洁的发动机机油润滑一下转速传感器密封件。    
-     -     -     在拧紧螺栓之前确保转速传感器已经安装到位。    

Caterpillar Information System:

797 Off-Highway Truck Electric Drive Pump (Powered Stairway) Oil - Change - If Equipped
The Long Term Storage and Recovery of Certain Commercial Engines{0355, 1000} The Long Term Storage and Recovery of Certain Commercial Engines{0355, 1000}
C13, C15, and C18 Tier 4 Interim Engines Aftertreatment Cooling Fan - Test
C6.6 Marine Generator Set E539 High Intake Manifold Air Temperature
C6.6 Marine Generator Set E398 Low Fuel Rail Pressure
C6.6 Marine Generator Set E396 High Fuel Rail Pressure
C6.6 Marine Generator Set E362 Engine Overspeed
C13, C15, and C18 Tier 4 Interim Engines Data Link - Test
Procedure for Reworking the Diodes In the Alternator Charging Circuit{1405, 7451} Procedure for Reworking the Diodes In the Alternator Charging Circuit{1405, 7451}
C27 Generator Set Engines Coolant Temperature Sensor
Updating the Wiring Harness of the Engine Brake on Some C15 Engines{1290, 1408} Updating the Wiring Harness of the Engine Brake on Some C15 Engines{1290, 1408}
Recommended Storage Procedures For Hydraulic Excavators {0355, 1000, 1250, 7000} Recommended Storage Procedures For Hydraulic Excavators {0355, 1000, 1250, 7000}
797 Off-Highway Truck Platform (Powered Stairway) - Lubricate - If Equipped
C27 and C32 Tier 4 Engines Exhaust Manifold
Inspection of the Duo-cone Seal Gp{4050, 4051, 7561} Inspection of the Duo-cone Seal Gp{4050, 4051, 7561}
C4.4 Industrial Engine Monitoring System - Table for the Indicator lamps
2012/03/09 New Boots for the Joystick Control in the Operator Station Are Now Available for Certain Excavators {5705}
CX31-P600 Petroleum Transmission Magnetic Screen (Transmission) - Clean - Dropbox
C15 and C18 Industrial Engines Fuel Filter Base - Remove and Install - Secondary
Procedure for the Proper Installation and Alignment of the Base Mounts on C18 Marine Generator Sets{1021, 7002} Procedure for the Proper Installation and Alignment of the Base Mounts on C18 Marine Generator Sets{1021, 7002}
2010/02/10 New Communication Software for the PL1000E Is Now Used on Commercial Engines {7620}
2010/02/03 A Long Term Storage and Recovery Procedure Is Now Available for Certain Commercial Engines {1000}
EMCP4.1/EMCP4.2 Component Location
C175-16 Locomotive Engine Fuel Control Manifold
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.