Oil Filter (Final Drive)
Show/hide table
Illustration 1 | g01953869 |
Note: Lubricate the O-ring seal (5) with the lubricant that is being filtered.
Note: Before the maximum torque, the filter housing group (2) must contact the bottom of the base assembly (1). Do not use an air wrench to tighten the filter housing group.
(2) Torque for the filter housing group ...
(3) 334-2679 Spring
- Length under test force ...
57.57 mm (2.267 inch) - Test force ...
179.53 ± 8.98 N (40.36 ± 2.02 lb) - Free length after test ...
85.6 mm (3.37 inch) - Outside diameter ...
22.35 mm (0.880 inch) - Test force ...
(4) 334-2680 Spring
- Length under test force ...
57.57 mm (2.267 inch) - Test force ...
98.67 ± 4.93 N (22.18 ± 1.11 lb) - Free length after test ...
68.2 mm (2.69 inch) - Outside diameter ...
16.17 mm (0.637 inch) - Test force ...
(6) Torque for the plug assembly ...
Caterpillar Information System:
C13, C15, and C18 Tier 4 Interim Engines Injector Solenoid - Test
797F and 797F XQ Off-Highway Truck Hydraulic System Hydraulic Tank (Brake, Hoist, Steering) - Extra Retarding
C13 Tier 4 Final Engines Valve Rocker Arm
C18 Power Module Setup
G3304B and G3306B Engines Rocker Shaft - Disassemble
C18 Power Module Before Starting Engine
C9.3 Tier 4 Final Engines Diesel Particulate Filter Has High Ash Load
C9.3 Engines for Caterpillar Built Machines Fumes Disposal Filter - Remove and Install
793F AC Off-Highway Truck Hydraulic and Braking System Check Valve (Hoist Pilot Oil)
793F and 793F CMD Off-Highway Truck Braking System Shuttle Valve (Service Brake)
793F AC Off-Highway Truck Hydraulic and Braking System Control Valve (Traction Control Signal)
C4.4 Industrial Engine Radiator Pressure Cap - Clean/Replace
G3304B and G3306B Engines Rocker Shaft - Assemble
2009/07/27 Improved Procedure for the Retention of the Identification Film for the Roll Over Protective Structure (ROPS) and Falling Object Protective Structure (FOPS) {7323, 7325, 7405, 7557}
G3304B and G3306B Engines Valve Lifter - Remove
G3304B and G3306B Engines Welding Precaution
G3304B and G3306B Engines Valve Lifter - Install
G3304B and G3306B Engines Troubleshooting Data Sheet
793F and 797F Off-Highway Trucks Power Train Electronic Control System Using Caterpillar Electronic Technician to Determine Diagnostic Codes
793F CMD Off-Highway Truck (Command for Hauling) Power Train Electronic Control System Engagement Pressure for the Transmission Clutch - Calibrate
793F CMD Off-Highway Truck (Command for Hauling) Power Train Electronic Control System Fill Time for the Transmission Clutch - Calibrate
G3304B and G3306B Engines Inlet and Exhaust Valves - Remove and Install
797F and 797F XQ Off-Highway Truck Power Train Gear Pump (Brake, Rear Axle Lubrication) - Extra Retarding
797F and 797F XQ Off-Highway Truck Braking System Motor Rotating (Brake Cooling) - Extra Retarding