C9.3 Tier 4 Final Engines Caterpillar


Diesel Particulate Filter Has High Ash Load

Usage:

D6T 2B3
本步骤涉及以下故障诊断代码:

表 1
故障诊断代码    
J1939 代码     CDL 代码     说明     注释    
3720-15     E997(1)     微粒收集器 #1 烟灰负载百分比:高 - 最低严重程度(1)     没有根据保养周期表清洁柴油微粒滤清器。    
3720-16     E997(2)     微粒收集器 #2 烟灰负载百分比:高 - 中等严重程度(2)     没有根据保养周期表清洁柴油微粒滤清器。 正在发生更加频繁的再生。    

注: 下面以概率的先后顺序列出了这些步骤。 依次完成这些步骤。

表 2
故障诊断与排除测试步骤     数值     结果    

1. 确定激活代码,

A. 在 Caterpillar 电子技师(ET)和电子控制模块(ECM)之间建立通信。

B. 在执行任何故障诊断与排除或清除故障诊断代码前,从发动机 ECM 下载"保修报告"。

C. 确定代码。
   

激活的代码    

结果:激活了 E997(1)或 3720-15 代码。

转至测试步骤 2。

结果:激活了 E997(2)或 3720-16 代码。

转至测试步骤 3。
   

2. 确定 DPF 的最近清洁时间。

A. 确定 DPF 的上次清洁时间。
   

DPF 清洁    

结果:没有根据保养周期表清洁柴油微粒滤清器。 操作和保养手册内列出了保养周期表。

转至测试步骤 3。

结果:根据保养周期表清洁了柴油微粒滤清器。 在最近 500 小时内清洁了柴油微粒滤清器,但没有复位发动机烟灰模式。 复位发动机烟灰模式。 关于复位烟灰模式方面的信息,请参阅故障诊断与排除, "Cat ET 维修功能,DPF 烟灰维修"。

结果:已根据保养手册清洁了 DPF,但发动机工作时间已超过 500 小时。 另外,也没有复位发动机烟灰模式。

转至测试步骤 3。    

3. 清洁 DPF

A. 清洁 DPF。 请参阅专门说明书, REHS5045, "配有柴油微粒滤清器(DPF)的 Tier 4 产品上柴油微粒滤清器(DPF)的保养"。 关于正确步骤,请参阅系统操作、测试和调整, "柴油微粒滤清器 - 清洁"。

烟灰维修再生后,仪表上将会延时显示烟灰积聚量。
   

DPF    

结果:清洁了 DPF。

确认故障已排除。
   

按所列步骤顺序完成以上步骤。

以上步骤解决了此问题。 将发动机重新投入使用。

以上步骤没有解决问题。

联系当地 Cat 代理商的技术通信员(TC)。 如需进一步的帮助,您的 TC 可以通过代理商解决方案网络(DSN)与您交谈。

Caterpillar Information System:

C9.3 Engines for Caterpillar Built Machines Fumes Disposal Filter - Remove and Install
793F AC Off-Highway Truck Hydraulic and Braking System Check Valve (Hoist Pilot Oil)
793F and 793F CMD Off-Highway Truck Braking System Shuttle Valve (Service Brake)
793F AC Off-Highway Truck Hydraulic and Braking System Control Valve (Traction Control Signal)
C4.4 Industrial Engine Radiator Pressure Cap - Clean/Replace
C7.1 Industrial Engine and Generator Set System Configuration Parameters
793F and 797F Off-Highway Trucks Chassis Electronic Control System MID 087 - CID 0144 - FMI 06
793F and 797F Off-Highway Trucks Chassis Electronic Control System MID 087 - CID 0144 - FMI 03
793F and 797F Off-Highway Trucks Chassis Electronic Control System MID 087 - CID 0144 - FMI 05
966M and 972M Wheel Loaders Power Train, Steering, Braking, Hydraulic & Machine Systems Check Valve (Brake Accumulator)
793F AC Off-Highway Truck Hydraulic and Braking System Check Valve (Parking Brake Release)
C13, C15, and C18 Tier 4 Interim Engines ARD Temperature Is Low
C18 Power Module Before Starting Engine
G3304B and G3306B Engines Rocker Shaft - Disassemble
C18 Power Module Setup
C13 Tier 4 Final Engines Valve Rocker Arm
797F and 797F XQ Off-Highway Truck Hydraulic System Hydraulic Tank (Brake, Hoist, Steering) - Extra Retarding
C13, C15, and C18 Tier 4 Interim Engines Injector Solenoid - Test
797F and 797F XQ Off-Highway Truck Power Train Oil Filter (Final Drive)
G3304B and G3306B Engines Rocker Shaft - Assemble
2009/07/27 Improved Procedure for the Retention of the Identification Film for the Roll Over Protective Structure (ROPS) and Falling Object Protective Structure (FOPS) {7323, 7325, 7405, 7557}
G3304B and G3306B Engines Valve Lifter - Remove
G3304B and G3306B Engines Welding Precaution
G3304B and G3306B Engines Valve Lifter - Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.