Front Cover - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 9S-3263 | Thread Lock Compound | - |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the gasket. Replace the gasket, if necessary.
- Position the gasket and cover (3) on the front housing.
- Install studs (2).
Note: Bolt (4) is a through bolt. Apply Tooling (A) to the threads prior to installation.
- Install bolt (4).
- Install bolts (1).
Show/hide table
Illustration 1 | g01292465 |
Note: The rear face of cover (3) and the front face of the housing must be clean.
End By:
- Install the crankshaft front seal. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Install".
- Install the fan drive mounting group. Refer to Disassembly and Assembly, "Fan Drive Mounting Group - Remove and Install".
- Install the fuel transfer pump. Refer to Disassembly and Assembly, "Fuel Transfer Pump - Install".
Caterpillar Information System:
C13 Engine Front Cover - Remove
C13 Engine Crankshaft Front Seal - Install
C13 Engine Crankshaft Front Seal - Remove
C13 Engine Rear Power Take-Off (RPTO) - Install
C7 On-highway Engine Diesel Particulate Filter
C13 Engine Rear Power Take-Off (RPTO) - Remove
C13 Engine Flywheel Housing - Remove and Install
C13 Engine Flywheel - Install
C13 Engine Flywheel - Remove
Color Change for Cylinder Rod Seals (Wiper, U-Cup and Buffer){5100, 7555, 7562} Color Change for Cylinder Rod Seals (Wiper, U-Cup and Buffer){5100, 7555, 7562}
C13 Engine Water Temperature Regulator - Remove and Install
C13 Engine Water Pump - Install
C13 Engine Gear Group (Front) - Remove
C15 and C18 Industrial Engines Combustion Head - Remove and Install
C13 Engine Gear Group (Front) - Install
C13 Engine Housing (Front) - Remove
C7 On-highway Engine Diesel Particulate Filter Temperature and Pressure Sensor
C13 Engine Housing (Front) - Install
789D, 793F, and 797F Off-Highway Truck Monitoring System Charging System
2009/04/20 An Improved Exhaust Bellows Assembly Is Used on 3500HD Locomotive Engines {1052, 1053}
C13 Engine Accessory Drive - Remove
C13 Engine Accessory Drive - Install
C13 Engine Valve Mechanism Cover - Remove and Install
C13 Engine Valve Mechanism Cover Base - Remove and Install