Rocker Shaft and Pushrod - Remove
Removal Procedure
Start By:
- Remove the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Loosen adjustment screws (1) on each rocker arm. This will help ease the tension on rocker shaft assembly (4) during removal.
Show/hide table
Illustration 1 | g00648792 |
- Remove three nuts (2) and bolt (3) from rocker shaft assembly (4). Begin with the end brackets and move toward the center.
Note: It is not necessary to remove the oil supply tube in order to remove the rocker shaft assembly and the pushrods.
- Remove rocker shaft assembly (4) from the cylinder head.
- Remove the oil seal from the oil supply passage in the cylinder head.
- Place an identification mark on the pushrods for installation. Remove pushrods (5) from the cylinder head.
Show/hide table
Illustration 2 | g00648841 |
Caterpillar Information System:
2009/04/13 Parts For Caterpillar Switch Gear Are Now Available {4491}
2009/04/06 New Information Is Available For Intelligent Switchgear Organization (ISO) Products {4491}
C13 Engine for Caterpillar Built Machines Exhaust Gas Valve (NRS) - Assemble
C13 Engine for Caterpillar Built Machines Exhaust Gas Valve (NRS) - Disassemble
Guidelines for Inspection of the 303-8189 Flexible Coupling Gp {3252, 4450} Guidelines for Inspection of the 303-8189 Flexible Coupling Gp {3252, 4450}
C13 Engines for Caterpillar Built Machines Exhaust Gas Valve (NRS) - Remove and Install
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 1273 - FMI 14
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 1273 - FMI 09
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 1273 - FMI 02
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 0811 - FMI 09
2009/04/27 New Software for C15 Generator Sets Is Available {1901, 1920}
C13 Engines for Caterpillar Built Machines Exhaust Sensor Lines - Remove and Install - Venturi
3054B Industrial Engine Engine Oil Bypass Valve - Remove and Install
3054B Industrial Engine Rocker Shaft and Pushrod - Install
C18 Marine Engines Overhaul (Top End)
C7.1 Industrial Engine Safety Messages
Replacement of the Fuel Manifold (Rail){1251, 1290} Replacement of the Fuel Manifold (Rail){1251, 1290}
C7.1 Industrial Engine General Hazard Information
C9.3 Tier 4 Interim Engines Fuel Rail Pressure Is Low
CX31-P600 Petroleum Transmission Transmission Warm-up
CX31-P600 Petroleum Transmission Transmission Control
CX31-P600 Petroleum Transmission Retarder Operation
CX31-P600 Petroleum Transmission Transmission Cooling System
C7.1 Industrial Engine Burn Prevention