Engine Oil Pressure Sensor - Remove and Install
- 拆下螺栓 (1) 和 (2)。 松开螺栓 (3),然后将线束组件 (4) 放置到一边。
Show/hide table
图 2 g02164147 - 断开线束组件 (5) 后拆下机油压力传感器 (6)。
- 将 O 形密封圈从发动机机油压力传感器 (6) 上拆下。
Show/hide table
图 1 | g02164146 |
- 按与拆卸相反的顺序安装发动机机油压力传感器 (6)。
- 将发动机机油压力传感器 (6) 拧紧至扭矩为
10 ± 2 N·m (89 ± 18 lb in) 。 - 拧紧螺栓 (3) 至扭矩为
7.0 ± 0.5 N·m (62 ± 4.5 lb in) 。
注: 不要使用传感器的塑料部分预紧传感器。 使用传感器的金属六角部分预紧传感器。 如果使用传感器的塑料部分预紧传感器,则可能会损坏传感器。
- 将发动机机油压力传感器 (6) 拧紧至扭矩为
Caterpillar Information System:
C13, C15, and C18 Tier 4 Interim Engines Engine Does Not Crank
C12 Marine Engines Fuel System Secondary Filter - Replace
C15 and C18 Engines for Caterpillar Built Machines Crankcase Pressure Sensor - Remove and Install
C12 Marine Engines Engine Valve Lash - Inspect/Adjust
C15 and C18 Industrial Engines Atmospheric Pressure Sensor - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Oil Contains Coolant
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Rotator
C7.1 Industrial Engine and Generator Set Sensors and Electrical Connectors
C4.4 Industrial Engine Piston and Rings
C6.6 Industrial Engine Main Bearing Journal
C6.6 Industrial Engine Cylinder Head Valves
C13 Engines for Caterpillar Built Machines Exhaust Cooler (NRS) - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Engine Has Early Wear
C9.3 Engines for Caterpillar Built Machines Fuel Consumption Is Excessive
C13 Engine for Caterpillar Built Machines Crankshaft Rear Seal - Remove and Install
C32 Auxiliary Engine Maintenance Recommendations
C9.3 Engines for Caterpillar Built Machines Engine Has Mechanical Noise (Knock)
C9.3 Engines for Caterpillar Built Machines Valve Lash Is Excessive
C6.6 Industrial Engine Engine Oil Pressure
C6.6 Industrial Engine Starter Motor
C13, C15, and C18 Tier 4 Interim Engines Cooling Fan Is Always ON
C15 and C18 Engines for Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install
C13, C15, and C18 Tier 4 Interim Engines Power Is Intermittently Low or Power Cutout Is Intermittent
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 0271 - FMI 03