Electronic Control Module (ECM) - Replace
在更换 ECM 之前，确保更换是必需要做的操作。 ECM 不太可能是故障的原因。 务必检查并确认 ECM 标有 "+ Battery（蓄电池正极）"的所有触点上有电。
注: 配置软件损坏或软件不正确可能会导致 ECM 错误地报告诊断代码。 在更换 ECM 之前，使用正确的配置软件对 ECM 进行闪存设定来确认故障与软件损坏无关。 请参阅测试和调节, "电子控制模块（ECM）- 闪存编程"。
步骤
- 将断路开关和钥匙起动开关转到 OFF（断开） 位置。
- 从 ECM 上断开机器线束接头。
- 确认更换的 ECM 的零件号正确。
- 安装更换的 ECM。
- 将机器线束与 ECM 相连。
- 将断路开关和钥匙起动开关转到 ON（接通）位置。
- 如有必要，采用 Electronic Technician (ET) 安装配置软件。 请参阅本手册中的测试和调整, "电子控制模块（ECM）- 闪存编程"一节。
- 确认 ECM 正常工作。
Caterpillar Information System:
345C and W345C Excavators and 345C MHPU Mobile Hydraulic Power Unit Machine Electronic Control System Electronic Control Module (ECM) - Replace
M316D, M318D and M322D Wheeled Excavators Machine Systems Boom - Install - Standard Boom
2008/09/22 Improved Material is Now Used on Hose Assemblies that Are for the Engine Oil Filter for Certain Mini Hydraulic Excavators {1306, 1307, 1308}
Low or Erratic Hydraulic Power is Experienced on Certain Wheeled Excavators{5455} Low or Erratic Hydraulic Power is Experienced on Certain Wheeled Excavators{5455}
314D CR Hydraulic Excavator Machine Systems Swing Motor - Remove
2008/06/30 Installation Procedure for the Fuel Transfer Kit on the Hydraulic Electronic Unit Injector (HEUI) Pump {1256}
Temporary Weld Repair for Crack in Lower Jaw of Shear{6349} Temporary Weld Repair for Crack in Lower Jaw of Shear{6349}
2008/07/14 Correction to the Parts Manual , "Filter Gp-Fuel" for Excavators {1261}
320D Excavator Mirror - If Equipped
314D CR Hydraulic Excavator Machine Systems Speed Control - Remove and Install
314D CR Hydraulic Excavator Machine Systems Pressure Switch (Refrigerant Pressure Cutoff) - Remove and Install
2008/09/22 A New Connector and a New Elbow Are Available for Increased Reliability of the Solenoid Valve on the Main Hydraulic Pump {5057, 5059}
314D CR Hydraulic Excavator Machine Systems Swing Motor - Install
323D MHPU Mobile Hydraulic Power Unit Machine System Specifications Fuel Tank
385C Excavator and 385C Front Shovel Machine System Specifications Accumulator (Pilot)
330B Excavator Machine System Specifications Flow Control Valve
2008/08/11 New Software For the Engine ECM is Now Available {1901, 7600, 7620}
2008/07/14 Updated Electronic Unit Injectors {1290, 1901}
314D CR Hydraulic Excavator C4.2 Engine Supplement Refrigerant Compressor - Remove and Install
2008/09/01 The Pump Control Valve Has Been Improved on Certain Mini Hydraulic Excavators {5455}
314D CR Hydraulic Excavator Machine Systems Pilot Valve (Joystick) - Remove - Right Hand
Procedure for Replacing the Pump Control Valve on Certain Mini Hydraulic Excavators{5455} Procedure for Replacing the Pump Control Valve on Certain Mini Hydraulic Excavators{5455}
345D MHPU and 349D MHPU Mobile Hydraulic Power Units Machine System Pilot Valve (Boom Drift Reduction)
319D Excavator Machine System Specifications Pilot Valve (Travel)