Display Registration and Activation
要想使用 AccuGrade 系统,必须注册显示器后激活显示器。 Caterpillar 代理商可注册显示器后激活显示器。 注册显示器时,会收到用来激活显示器的唯一注册密码。 此注册过程将使显示器随软件升级的发布而升级。
注: 在 AccuGrade 系统可以使用前,还需要激活电子控制模块。
获得注册密码
Show/hide table
图 1 | g01501951 |
注册页面示例 |
请参阅以下步骤获得用来激活新显示器的注册密码。
- 记下显示器识别标牌上的序列号。
- 访问以下网站:"www.techproductregistration.com"。
关于注册表的示例,请参阅图 1。
注: 如果无法访问网站,请拨打电话888-223-7539 以手动注册软件。
- 填写网站上的注册表。
注: 在不同区域输入信息后,可能需要刷新网页。
关于详细信息,请参阅专门说明书, REHS3666。
- 选择 "Confirm(确认)"。
30 分钟内,将向代理商在网站表格上递交的 e-mail 地址发送电子邮件。 此电子邮件内具有激活显示器所需要的注册密码。
- 将注册密码交给相关人员,以便将密码输入显示器内。
保存此注册信息供将来参考。
将注册密码输入显示器
请参阅以下步骤将注册密码输入显示器。
- 通过将机器的钥匙起动开关转到 "ON" 位置起动系统。 随后按电源键。
显示器将通电起动。 类似于图 2 的屏幕将出现。
Show/hide table
图 2 | g01314647 |
- 执行以下两个选项之一:
- 将获得的注册密码文件复制到数据卡的根文件夹内。 按 "OK"。
- 输入获得的 24 位字符选项密码。 使用显示器键盘上的箭头键。 按 "OK" 键。
如果成功,"Option Keys File Loaded(选项密码文件已加载)"对话框出现。 请参阅插图 4。 这表示一个选项密码已成功加载。
- 将获得的注册密码文件复制到数据卡的根文件夹内。 按 "OK"。
Show/hide table
图 3 | g01314650 |
Show/hide table
图 4 | g01314651 |
- 按 "OK" 键。
"平面图"出现。
注: 如果密码不激活,确认密码是否输入正确。 确认识别标牌上的序列号与电子序列号相同。
Caterpillar Information System:
C175-16 and C175-20 Generator Set Engines Prelubrication Pump Problem
3500 Generator Sets Air Starting Motor Lubricator Oil Level - Check - If Equipped
3500 Generator Sets Air Starting Motor Lubricator Bowl - Clean - If Equipped
C175-16 and C175-20 Generator Set Engines Engine Top Speed Is Not Obtained
G3520B Engines Piston and Rings
2008/05/05 New AccuGrade® Firmware is Now Available {7220, 7620}
2008/04/28 Make Sure That the Bellows Assembly for the Turbocharger Is Installed Correctly {1052}
345D, 349D and 349D2 Excavators Camera Harness - Disconnect and Connect
Loose Caps on Oil Filler Tubes for C7, C9, and C13 On-highway Engines{1316} Loose Caps on Oil Filler Tubes for C7, C9, and C13 On-highway Engines{1316}
3512C Engine for Caterpillar Built Machines Crankshaft - Install
3512C Engine for Caterpillar Built Machines Crankshaft - Remove
G3520E Generator Set Engines Engine Oil Pump
C175-16 and C175-20 Generator Set Engines Ether Starting Aid - Test
AccuGrade® GPS (CD700) Display Language
3406C Engines for Caterpillar Built Machines Fuel Filter Base
Broken Tappet Springs on the 3406E, 3456, C-15, C-16, C-18, and C32Engines{1290} Broken Tappet Springs on the 3406E, 3456, C-15, C-16, C-18, and C32Engines{1290}
AccuGrade® GPS (CD700) CAN Data Link - Test
Oil and Coolant Leaks of the Plate Gasket on the C27 and C32 Engines{1201, 1201} Oil and Coolant Leaks of the Plate Gasket on the C27 and C32 Engines{1201, 1201}
2008/04/21 New Software Is Now Available for Improved Engine Start-up {1901, 7620}
2008/05/01 An Improved Adapter for the Fuel Priming Pump Is Now Used {1258}
2008/04/14 A New Exhaust Valve is Used {1100, 1105}
Filtration Procedure for Motor Grader & Paving Equipment Hydraulic Oil {0680, 0768, 5050, 5056} Filtration Procedure for Motor Grader & Paving Equipment Hydraulic Oil {0680, 0768, 5050, 5056}
Air Conditioning and Heating R134a for All Caterpillar Machines Service Intervals
2008/04/14 Water Pump Operation {1361}