Start By:
- Remove the tilt control valve. Refer to Disassembly and Assembly, "Tilt Control Valve (Dual) - Remove".
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
- Remove nut (2) and coil assembly (1).
Show/hide table
Illustration 2 g01481332 - Remove cartridge assembly (3).
Show/hide table
Illustration 3 g00401988 - Remove seals (4) from cartridge assembly (3).
Show/hide table
Illustration 4 g01481336 Show/hide tableIllustration 5 g01481312 Show/hide tablePersonal injury can result from being struck by parts propelled by a released spring force.
Make sure to wear all necessary protective equipment.
Follow the recommended procedure and use all recommended tooling to release the spring force.
- Remove bolts (5) from cover (6).
- Remove cover (6), seal (9), spring (8), and retainer (7).
Show/hide table
Illustration 6 g01481342 Show/hide tableIllustration 7 g01481316 Show/hide tablePersonal injury can result from being struck by parts propelled by a released spring force.
Make sure to wear all necessary protective equipment.
Follow the recommended procedure and use all recommended tooling to release the spring force.
- Remove bolts (10) from cover (11).
Note: Stem (12) is not symmetrical. Put alignment marks on the stem before removal.
- Remove cover (11), seal (13), spring (15), retainer (14), and stem (12).
Illustration 1 | g01481328 |