The Body and Canopy Assembly has been Lengthened on Specific Off-Highway Trucks{7258} Caterpillar


The Body and Canopy Assembly has been Lengthened on Specific Off-Highway Trucks{7258}

Usage:

793F SSP
Off-Highway Truck:
793F (S/N: SSP1-UP)

Introduction

The problem that is identified in the technical information bulletin that follows does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.

Problem

The canopy on the bodies on 793F off-highway trucks has been lengthened in order to cover the walkway assembly that is on the front of the truck. Fully raise the truck body. The distance from the top of the canopy to the floor changed. You must check the height of the ceiling in the shop. The new, longer canopy could hit the ceiling. This could cause damage to the ceiling.

Solution

Before you raise the truck body to the full DUMP position, make sure that the new, longer canopy will not hit the ceiling in the shop.




Illustration 1g01442238

Refer to Illustration 1. The first measurement is for a truck that contains the former truck body. The largest tires that are available are also installed on the truck. The distance from the top of the truck body (1) to the floor (2) was 13171 mm (518.5 inch).




Illustration 2g01442245

Refer to Illustration 2. The second measurement is for a truck that contains the new truck body. The largest tires that are available are also installed on the truck. The distance from the top of the truck body (3) to the floor (4) is 13615 mm (536.0 inch).

Caterpillar Information System:

AP600D and BG600D Asphalt Pavers Operator Controls - Secondary Control Panel
AP600D and BG600D Asphalt Pavers Operator Controls - Main Control Panel
450E Backhoe Loader MID 039 - CID 0247 - FMI 09
24M Motor Grader Machine Systems Battery - Remove and Install
2007/12/24 Combustion Inserts in the Cylinder Head {1100}
2007/12/31 New Oil Suction Tube {1302}
2007/12/17 Correction to Operation and Maintenance Manual , "Steering Frame Lock" {7506}
2007/12/17 Correction to Operation and Maintenance Manual , "Fuel Shutoff Valve" {1329}
2007/12/17 Correction to Operation and Maintenance Manual , "Indicators" {7400, 7450}
2007/12/17 Correction to Operation and Maintenance Manual , "Additional Messages" {7000}
R2900G (JLK) Load Haul Dump Retrofitting The Battery Isolation Control{1402, 1408, 1411} R2900G (JLK) Load Haul Dump Retrofitting The Battery Isolation Control{1402, 1408, 1411}
AP600D and BG600D Asphalt Pavers Daily Inspection
2007/12/31 New Power Train Software is Now Available {7620}
3524B and C175 Engines for Off-Highway Truck/Tractors Accessory Drive
450E Backhoe Loader MID 039 - CID 0367 - FMI 04
785D Off-Highway Truck Hoist, Torque Converter and Brake Tank Suction Screen - Inspect/Clean/Replace
2008/05/12 An Improved Pinion Shaft with a New Rugged Bolted Joint Provides Consistent Torque on the Circle Drive {5207}
2007/12/31 New Mounting Hardware is Now Used {7258}
450E Backhoe Loader MID 039 - CID 0368 - FMI 03
450E Backhoe Loader MID 039 - CID 0368 - FMI 04
450E Backhoe Loader MID 039 - CID 0490 - FMI 03
450E Backhoe Loader MID 039 - CID 0490 - FMI 04
259B3 Compact Track Loader, 247B3 and 257B Series 3 Multi Terrain Loaders and 216B Series 3, 226B3, 236B3, 242B Series 3 and 252B Series 3 Skid Steer Loaders Bogie Wheel
259B3 Compact Track Loader, 247B3 and 257B Series 3 Multi Terrain Loaders and 216B Series 3, 226B3, 236B3, 242B Series 3 and 252B Series 3 Skid Steer Loaders Idler Wheel
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.