2007/12/17 Caterpillar


Correction to Operation and Maintenance Manual , "Indicators" {7400, 7450}

Usage:

R1700G SBR
Load Haul Dump:
R1700G (S/N: SBR591-UP)
Operation and Maintenance Manual, SEBU8211, "R1700G Load Haul Dump", "Indicators". This manual is part of Service Manual, KENR6258 Volume II.

The following information is an addition to the operation section of the Operation and Maintenance Manual. The new information is effective with SBR591-UP.




Illustration 1g01275469


Action Lamp (1) - This indicator flashes to indicate a Warning Category 2 or a Warning Category 3 has been registered by the Caterpillar Monitoring System.


Automatic Lubrication Indicator (2) (If Equipped) - This indicator will be on when there is a fault in the automatic lubrication system. Report the fault to service personnel when convenient. This indicator will be on for two seconds after the engine starts in order to alert the operator that the indicator is functioning properly. It is important for the operator to visually inspect this indicator. If the indicator does not come on after start-up, or if the indicator glows dimly after start-up, or if the indicator remains on, stop the engine and find the cause.


Exhaust Back Pressure Indicator (3) (If Equipped) - Indicates high exhaust back pressure. If back pressure is over 6 kPa (25 inches H2O), the light will illuminate and the exhaust purifilter must be cleaned.


Primary/Secondary Steering Indicator (4) (If Equipped) - This indicator will be on if there is a steering system failure in either the primary or secondary steering systems.

Note: The secondary steering system only operates while the machine is moving.


NOTICE

If the primary/secondary steering indicator flashes, cease operation, quickly move the machine to a safe area and shut the machine down. Inspect and rectify the cause of the problem before recommencing operation.



Residual Brake Oil Pressure Indicator (5) (If Equipped) - Indicates that there is oil pressure in the service brake section of the wheel brakes. The lamp will illuminate when the service brakes are applied. The lamp should go out when the brakes are released. If this indicator stays on, the brakes are holding residual brake oil pressure. Stop the machine and investigate the cause.


Ride Control Indicator (6) (If Equipped) - Indicates the ride control system is activated.


Autodig Indicator (7) (If Equipped) - Indicates an Autodig cycle has been initiated.

Caterpillar Information System:

2007/12/17 Correction to Operation and Maintenance Manual , "Additional Messages" {7000}
R2900G (JLK) Load Haul Dump Retrofitting The Battery Isolation Control{1402, 1408, 1411} R2900G (JLK) Load Haul Dump Retrofitting The Battery Isolation Control{1402, 1408, 1411}
AP600D and BG600D Asphalt Pavers Daily Inspection
R1700G Load Haul Dump Machine Electrical System Battery Isolation Control
AP600D and BG600D Asphalt Pavers Specifications
259B3 Compact Track Loader, 247B3 and 257B Series 3 Multi Terrain Loaders and 216B Series 3, 226B3, 236B3, 242B Series 3 and 252B Series 3 Skid Steer Loaders Track Tensioner
2008/02/25 A New Plug and O-ring Are Now Used on the Cylinder Head {1100}
2008/02/25 A New Plug Assembly Is Used on the Cylinder Head of Certain Machines Engines {1100}
259B3 Compact Track Loader, 247B3 and 257B Series 3 Multi Terrain Loaders and 216B Series 3, 226B3, 236B3, 242B Series 3 and 252B Series 3 Skid Steer Loaders Sprocket
AP655D and BG655D Asphalt Pavers Sound Information and Vibration Information
2007/12/17 An Improved Fitting Assembly Is Available for Certain Backhoe Loaders to Improve Serviceability {6506}
R1700G Load Haul Dump Fire Extinguisher Location
2007/12/17 Correction to Operation and Maintenance Manual , "Fuel Shutoff Valve" {1329}
2007/12/17 Correction to Operation and Maintenance Manual , "Steering Frame Lock" {7506}
2007/12/31 New Oil Suction Tube {1302}
2007/12/24 Combustion Inserts in the Cylinder Head {1100}
24M Motor Grader Machine Systems Battery - Remove and Install
450E Backhoe Loader MID 039 - CID 0247 - FMI 09
AP600D and BG600D Asphalt Pavers Operator Controls - Main Control Panel
AP600D and BG600D Asphalt Pavers Operator Controls - Secondary Control Panel
The Body and Canopy Assembly has been Lengthened on Specific Off-Highway Trucks{7258} The Body and Canopy Assembly has been Lengthened on Specific Off-Highway Trucks{7258}
2007/12/31 New Power Train Software is Now Available {7620}
3524B and C175 Engines for Off-Highway Truck/Tractors Accessory Drive
450E Backhoe Loader MID 039 - CID 0367 - FMI 04
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.