Rocker Arm and Shaft - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 8T-2998 | Lubricant | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply Tooling (A) to both ends of the pushrods.
- Lubricate the pushrods with clean engine oil. Install the pushrods and the valve bridges.
Show/hide table
Illustration 1 g00953116 Show/hide tableIllustration 2 g01435984 - Position rocker shaft (4) on the cylinder head. Install bolts (1). Tighten the bolts in a numerical sequence to standard torque.
- Apply Tooling (A) to each of the bottom faces of the rocker arms.
- Position rocker arm adjustment screws (2) and tighten nuts (3). Adjust the valve lash of the rocker arms. Refer to Testing and Adjusting, "Engine Valve Lash - Inspect/Adjust".
End By:
- Install the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Caterpillar Information System:
320D and 323D Excavators Hydraulic System Swing Drive
G3600 Engines Fuel Control - Test
345D MHPU and 349D MHPU Mobile Hydraulic Power Units Machine System Fasteners
C9 Petroleum Engines Cylinder Block Cover - Remove and Install
G3600 Engines Sensor Signal (PWM) - Test
C9 Petroleum Engines Crankcase Breather - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Valve Actuator (Variable) - Install
C4.4 Generator Set Engines Injector Solenoid Circuit - Test
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Assemble
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Disassemble
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Install
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Remove
Inspection and Reconditioning Procedures of Main Bearing Bores in Cylinder Blocks {1201, 1202, 1224, 1224} Inspection and Reconditioning Procedures of Main Bearing Bores in Cylinder Blocks {1201, 1202, 1224, 1224}
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) Troubleshooting Diagnostic Codes
2007/12/03 Improved Wiring for the Speed Control for the Electronic Governor {1408, 1417}
C9 Petroleum Engines Cylinder Head - Remove
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) Display of Voltage or Current or Power Is Inaccurate
G3600 Engines Prelubrication - Test
Caterpillar Machine Fluids Recommendations Distillate Diesel Fuel
C9 Petroleum Engines Cylinder Head - Install
C175 Generator Sets After Starting Engine
C9 Petroleum Engines Engine Oil Pan - Remove and Install
G3500B Engines Prelubrication Pump Problem
G3600 Engines Air Starting Motor Problem