Exhaust Manifold
Show/hide table
Illustration 1 | g01421828 |
(1) Cylinder head |
(2) Torque for 12 taperlock studs ... 35 ± 5 N·m (26 ± 4 lb ft)
(3) Install the gasket with the tab upward, as shown.
(4) Torque for two taperlock studs ... 35 ± 5 N·m (26 ± 4 lb ft)
(5) Apply 4C-5599 Anti-Seize Compound to the threads of the locknuts and the bearing surface of the locknuts and the washers before assembly.
Caterpillar Information System:
3608 Engine Vibration Damper - Remove
3608 Engine Rocker Arm - Disassemble
2007/10/22 The Programmable Monitoring System Parameters Have New Descriptions {1901, 1902, 7620}
3608 Engine Valve Mechanism - Install
3608 Engine Camshaft - Remove
2007/10/15 An Improved Air Cleaner Assembly is Now Used {1051, 1054}
2007/10/01 A New Base for the Engine Oil Cooler and Engine Oil Filter is Now Used {1306, 1378}
3176C and 3196 Engines for Caterpillar Built Machines Exhaust Manifold
3176C and 3196 Engines for Caterpillar Built Machines Exhaust Manifold
3608 Engine Idler Gears (Rear) - Install
3608 Engine Idler Gears (Rear) - Remove
3608 Engine Crankshaft Rear Seal - Install
C-10 and C-12 Truck Engines Exhaust Manifold
3608 Engine Crankcase Explosion Relief Valve - Remove and Install
3608 Engine Governor - Remove
3608 Engine Governor - Install
3500B and 3500C Marine Propulsion Engines Engine Will Not Crank
3176C and 3196 Engines for Caterpillar Built Machines Belt Tensioner
Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 1, 2, and 3) {5061, 5073} Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 1, 2, and 3) {5061, 5073}
3608 Engine Governor Drive - Assemble - Later
3608 Engine Fuel Injector - Remove
3608 Engine Fuel Injector - Install
C15 and C18 Petrolem Generator Set Engines Sensor Signal (Analog, Active) - Test
3608 Engine Fuel Priming Pump - Disassemble