Exhaust Manifold
Show/hide table
图 1 | g01421545 |
典型实例 (1) 缸盖 |
(2) 12 颗锥形锁紧螺柱的扭矩 ... 35 ± 5 N·m (26 ± 4 lb ft)
(3) 四根锥形锁紧螺柱的扭矩 ... 35 ± 5 N·m (26 ± 4 lb ft)
(4) 安装垫片时舌片向下,如图所示。
(5) 装配前,将 4C-5599 防咬合剂 涂抹到锁紧螺母的螺纹以及锁紧螺母和垫圈的支承表面上。
Caterpillar Information System:
3176C and 3196 Engines for Caterpillar Built Machines Exhaust Manifold
3608 Engine Idler Gears (Rear) - Install
3608 Engine Idler Gears (Rear) - Remove
3608 Engine Crankshaft Rear Seal - Install
C15 and C18 Petrolem Generator Set Engines Cat Data Link - Test
C15 and C18 Petrolem Generator Set Engines CAN Data Link - Test
C15 and C18 Petrolem Generator Set Engines Sensor Supply - Test
C11 and C13 Engines Engine Oil Filter Base
C-10 and C-12 Truck Engines Piston and Rings
G3520B Engine Control Panel - If Equipped
G3406 and G3412 Generator Set Engines Vibration Damper and Pulley
C13 Engine Crankshaft - Install
2007/10/01 A New Base for the Engine Oil Cooler and Engine Oil Filter is Now Used {1306, 1378}
2007/10/15 An Improved Air Cleaner Assembly is Now Used {1051, 1054}
3608 Engine Camshaft - Remove
3608 Engine Valve Mechanism - Install
2007/10/22 The Programmable Monitoring System Parameters Have New Descriptions {1901, 1902, 7620}
3608 Engine Rocker Arm - Disassemble
3608 Engine Vibration Damper - Remove
C-10 and C-12 Truck Engines Exhaust Manifold
C-10 and C-12 Truck Engines Exhaust Manifold
3608 Engine Crankcase Explosion Relief Valve - Remove and Install
3608 Engine Governor - Remove
3608 Engine Governor - Install