Turbocharger Outlet Temperature Sensor - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool. |
- Remove turbocharger outlet temperature sensor (1) .
Show/hide table
Illustration 1 | g01378667 |
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-3931     | Anti-Seize Compound     | -     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool. |
- Apply Tooling (A) onto the threads of turbocharger outlet temperature sensor (1). Install turbocharger outlet temperature sensor (1). Tighten turbocharger outlet temperature sensor (1) to a torque of 45 ± 5 N·m (33 ± 4 lb ft).
Show/hide table
Illustration 2 | g01378667 |
Caterpillar Information System:
C15 Generator Set Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
C15 On-Highway Engine Compression Brake
3408B and 3408C Industrial and Marine Engines Auxiliary Water Pump
C6.6 Engines for Caterpillar Built Machines Electronic Unit Injector - Install
320 Variable Gauge OEM Undercarriage Safety Messages
Proper Sizing of Ground to Neutral Cables{7405} Proper Sizing of Ground to Neutral Cables{7405}
120 Motor Graders Temperature Sensor (Hydraulic Oil)
C9 Agricultural Engine for Challenger Tractors Intake Manifold Air Temperature Is High
C9 Agricultural Engine for Challenger Tractors Exhaust Temperature Is High
C32 Marine Engine Control Panel
2007/07/09 Improved Mounting and Wiring for the Power Distribution Box {1000, 1408, 7426}
C32 Marine Propulsion Engines Indicator Lamp - Test
C15 On-Highway Engine Flame Detection Temperature Sensor - Remove and Install
Proper Marking of the Ground Connections{4459} Proper Marking of the Ground Connections{4459}
2007/05/21 New Procedure to Seal Planetary Tie Bolts to the Transmission Housing is Now Used {3160}
C15 Generator Set Engines Engine Pressure Sensor Open or Short Circuit - Test
2007/06/25 New O-Rings are Used {1307, 7555}
AccuGrade® GPS (CD700) Receiver Configuration
3408B and 3408C Industrial and Marine Engines Fuel Injection Pump
3408B and 3408C Industrial and Marine Engines Flywheel
C9 On-highway Engine Clean Gas Induction Cooler
C32 Marine Propulsion Engines Fuel Level - Test
Installation of New Injector Sleeve O-Ring Seals{1100, 1125} Installation of New Injector Sleeve O-Ring Seals{1100, 1125}
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C11I, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Power Train Electronic Control System MID 027 - CID 2999 - FMI 02