 | |
| Illustration 1 | g01377443 |
Rear view | |
 | |
| Illustration 2 | g01377455 |
Left side view | |
(1) Apply 154-9731 Thread Lock Compound to stud serration and both sides of gasket before assembly.
(2) Torque for the drain plug ... 55 ± 14 N·m (41 ± 10 lb ft)
(3) The front face of the flywheel housing and the rear face of the cylinder block must be free of oil, fuel, water, dirt and any other contaminants during assembly.
 | |
| Illustration 3 | g01392827 |
View A-A | |
(4) The pipe plug must not protrude above the surface after assembly.
(5) Apply a continuous bead of 4C-9612 Silicone Sealant immediately prior to assembling the flywheel housing. After assembly of the flywheel housing, remove any excess sealant from the flange with a straight edge.
 | |
| Illustration 4 | g01392832 |
(6) Cylinder block | |
(7) Apply 4C-9612 Silicone Sealant to the T-shaped joints immediately prior to the installation of the gasket for the pan. The application of the sealant should cover the entire width of the T-shaped joints, as shown.
 | |
| Illustration 5 | g01377457 |
Tightening sequence | |
Use the following procedure to tighten the bolts for the flywheel housing:
- Tighten bolts (1) through bolts (17) in a numerical sequence.
Torque ... 40 ± 10 N·m (30 ± 7 lb ft)
- Again tighten bolts (1) through bolts (8) in a numerical sequence.
Torque ... 135 ± 20 N·m (100 ± 15 lb ft)
- Again tighten bolts (9) through bolts (17) in a numerical sequence.
Torque ... 55 ± 10 N·m (41 ± 7 lb ft)